SuperPi32m 5GHz & 4GHz Haswell All Out Challenge!

[l0ud_sil3nc3]

testing a new cpu, seems to have strong IMC:

trcd 9 again?



still have to sort out temps for the above.

quickie aida run, no semblance of 32m stability with this one

[Tommi_Vercetti]

As a newbie of SuperPi 32M, here's my first trial @ 4GHz with my original Samsung DH0-CH9 ram.

Tommi_Vercetti- 7:31:156 - 40x100 - 1333.00MHz - 9-12-12-15-108-1 - ASROCK Z87M-OCF - Samsung Original DH0-CH9 4GB x2/SAMSUNG HCH9 - 2.15v - CPU H2O/RAM AIR





Cheers!
Tommi_Vercetti

[Splave]

good start

[Splave]

damn might have some potential here


no wazza, and not nearly tightened out all the way. was just going to play valids and get out of my comfort zone a bit and had some fun. Realized that the spreaders had popped off the outside on both sides. now that they are naked I will throw some better sinks on and try again maybe 5m57 hynixxxxx

[C-N]

Got a new chip for my UD5H to build up a new workstation but it looked good so swapped it out to the OCF!!

Early days but it runs like a champ

[Dumo]

Awesome chip C-N

5G/5G uncore with ambient temp.

[Splave]

Beauty!

[C-N]

Awesome chip C-N 5G/5G uncore with ambient temp.

Thanks mate, I was just very lucky. Silicone never fails to amaze me!!

Beauty!

She's a keeper

Small update / pre work run!!!

C-N- 5:57:500 - 49x102 - 1430MHz 9-12-12-16-108-1 - Asrock Z87 OCF/AC - Corsair 2666 C10 2x4GB/Samsung HCH9 - 2.0265v - CPU Water Kuhler 920 / Ram Air

[l0ud_sil3nc3]

l0ud_sil3nc3 - 7:23:938 - 39x102.6 - 1504.2 MHz - 11-14-13-24-266-1T - Z87M OCF - Corsair 3000 2x4GB/MFR - 1.85v - air@all



l0ud_sil3nc3 - 6:01:859 - 48x104.2 - 1527.8 MHz - 11-14-13-24-266-1T - Z87M OCF - Corsair 3000 2x4GB/MFR - 1.85v - air@all

[THERULE]

RULE- 5:57.922 - 48x104.2 - 1354.1 MHz - 7-11-7-24-74-1 - AsRock Z87 OCF-M - GSkill Pi 2200mhz C7 /PSC - 2.25V - LN2 CPU/Mem









First time memory under LN2, some instability below -90?C, close 5.57.500 but the screen is incorrect.
Try again this week-end.

[l0ud_sil3nc3]

l0ud_sil3nc3 - 6:01:563 - 48x104.2 - 1527.8 MHz - 11-14-13-24-266-1T - Z87M OCF - Corsair 3000 2x4GB/MFR - 1.85v - air@all

[Splave]

Guess I need to run mfr again bastage!

maybe this stick (1.65v) and its brother (only does 1767 lmao)

[THERULE]

RULE - 5:57:422 - 48x104.2 - 1355.8 MHz - 7-11-7-24-72-1T - Z87M OCF - G.SKILL PI 2x2GB/PSC - 2.269v - LN2@ALL










Very hard to get this with 66% humidity

http://img46.imageshack.us/img46/213...pgaftbeibu.mp4

Enjoy!

[l0ud_sil3nc3]

RULE - 5:57:422 - 48x104.2 - 1355.8 MHz - 7-11-7-24-72-1T - Z87M OCF - G.SKILL PI 2x2GB/PSC - 2.269v - LN2@ALL

Very hard to get this with 66% humidity

http://img46.imageshack.us/img46/213...pgaftbeibu.mp4

Enjoy!

Great run

Do you have any fans redirecting the cold away from the mb?

[THERULE]

usually yes, not this time.
With very wet air there is a lot of condenses, so I tried to cover everything with a lot of blue paper.
Next time a water proof board will be better!

[Mafio]

RULE - 5:57:422 - 48x104.2 - 1355.8 MHz - 7-11-7-24-72-1T - Z87M OCF - G.SKILL PI 2x2GB/PSC - 2.269v - LN2@ALL

http://img826.imageshack.us/img826/7467/snwz.png

http://imageshack.us/a/img843/7210/5ydc.jpg

http://imageshack.us/a/img197/3906/ilvi.JPG

http://imageshack.us/a/img28/3861/6xny.jpg


Very hard to get this with 66% humidity

http://img46.imageshack.us/img46/213...pgaftbeibu.mp4

Enjoy!

Holy s**t, 2.25 volt.
Keep up the good work.

[THERULE]

you know it's all because of you, i learned from the best!
Thanks Fabio and come back to bench please!

[l0ud_sil3nc3]

same cpu from the prior session starting the night off well:



finally caught myself



getting closer. . .

l0ud_sil3nc3 - 5:55:672 - 49x102.1 - 1361 MHz - 6-10-6-24-64-1 - OCF - GSkill 2400 c8 2x2GB/PSC - 2.15V - LN2 @ all



and FAIL



sooooo close yet so far will keep going till I run out of juice since I will be out of town for most of the week which means no bench time

[bullant]

Really nice Loud,maybe was a 55.4--

Little improvement,should have some ln2 soon,been to long without it
bullant - 7:20.625 - 39x102.61 - 1368.3MHz - 8-12-8-28-82-1 - OCF - GSkill Pis 2x2GB/PSC - 1.935V -CPU-25,Memory AIR

[Splave]

great runs all around

[John Lam]

John Lam - 5:58.484 - 50x100 - 1400.0MHz - 9-12-12-15-108-1 - OCF - CORSAIR - 1.98V All AIR

i-RAM x 2

[MaJ0r]

John what boost gave you I-ram? And I see you use Vista style theme from desctop it's new idea for 32m or I miss something//

[John Lam]

John what boost gave you I-ram? And I see you use Vista style theme from desctop it's new idea for 32m or I miss something//

This is Offical Luna Theme from Microsoft Called "Zune", I ported from WinFLP OS , No TrueType Font used , only 1M memory used.

http://en.wikipedia.org/wiki/Windows_XP_themes

iRam has very fast transfer rate in 4K , extreme fast access time, doesn't slow down over time , and Unlimited write cycles compared to SSD if you always do Copy Wazza file.

[crustytheclown]

Crusty - 7:17:891 - 40x100.6 - 1334MHz 7-9-6-20-62-1 - Asrock Z87 OCF - Skillz 2133C8 2x2GB/BBSE - 1.91v - CPU SS / Ram LN2



New os new manual bat-style wazza

previus run with slightly slacker timings,the big difference is because of ocx tweaker,no affinity-priority... almost 1 sec slower...




and some pics of the session



the reason i did not test 5g at all...next time...



and some psc sticks to test... hopefully something good will come out

[MaJ0r]

Crusty want to see 5GHz time, will show us it )