Already known everything was properly checked attached.
Changes i did was set gpu straight again it was dropping down little like \ not massively like gpu was bend , Thank god its not bend.
Cleaned my pump took out rotor cleaned that asswell.
reduced tubing size little here and their so gpu would't hang all the way down.
for rest nothing changed.
also blocks i have in my loop and pump.
ek supreme hf full nicke old one with jet plate one which gave me 3 lpm before.
ek fc480 copper block
probably have like 1 lpm right now.
what i am thinking atm is that if not had jet plate put in properly that would just leak around jet plate.
pump seems to make noise asswell air in it constantly does't stay silent been like that now for 2 3 hours.
I'm suspecting jet plate finaly working like it should , Tough i have no idea what normal flow rate would be with jet plate one.
Anyway think i let it run now over night for leak testing, see if noise from pump becomes less.
Sorry if its unreadable i'm extreme stressed out that my back hurt like hell.
Bookmarks