Hello!
I have 3 x D5 Strong at 24V (in series). And now, after 1 month, one pump as I assume - dead. I have not analyzed yet what it was but one pump sometimes started to make a very loud crackle. Than even at 15V this hack stopped to work (Aquaero started to buzzing because flow rate dropped below 200 l/h). Than when I restarted all pumps - this thing immediately started to make those sounds).
So now I'm thinking what to do, use only two D5S at 24V (210 l/h) or buy another D5S and use it at 24V (260 l/h as it was) or use three of them at 15V (210 l/h).
Or buy Iwaki RD-30 and use it alone at 24V (I think it will be approximately like two D5S @ 24V). I'm sure that Iwaki RD-30, it's not a mass consumption product like Laing D5(S).
These three pumps are now installed as they were, I just disconnected the middle pump from the PSU and have not disassemble it (don't want to spend a time and just sick of it ). So only when a new pump will arrive, I will do something.
Also I want to write, that pumps are located in the kitchen, in the corner and under the table:
And packed into some towels (not on the photo) so it's a really silent thing even for a room (but better to install that thing in another place ). I'm not sure what will be with RD-30, but I guess equal (?).
Thanks!
But most sad that I played in BF3 and it was a hard round and as I heard a buzz from Aquaero, I had to exit the game and switch my PC off
Bookmarks