Repairing of 3 Single-stages: Vapo LS, Mach 1 and LD unit . WORKLOG

**piotres** · 09-03-2012, 03:14 PM

I have finished all of them a LONG time ago, but I haven't got much time to upload pictures....but here are them :

"LD" unit before mod:

"LD" unit after mod:

Temperature under 315W dummyload:

------------------------------------

Prometeia before mod:

Prometeia after mod:

Temperature under 315W dummyload:

-----------------------------------

All 3 units before mod:

All 3 units after mod:

I hope that You like them

.

Regards
Peter

**Buckeye** · 09-03-2012, 03:58 PM

Those came out darn nice Peter, good job !

**runmc** · 09-03-2012, 04:29 PM

I like

**Dumo** · 09-03-2012, 05:17 PM

Awesome works

With popularity of low clock benching (4.5Ghz~5Ghz) those small case single stage cooler comes in handy (especially with portability and decent load capacity).

**chaotic** · 09-04-2012, 03:45 AM

Nice work...what fans did you use?Deltas?

**Splave** · 09-04-2012, 04:25 AM

Beautiful

**mytekcontrols** · 09-04-2012, 05:29 AM

Amazing before and after photos. In their previous state they looked like they were one step away from the garbage bin. But now they appear to be better then new.

Great job as always

**piotres** · 09-04-2012, 01:44 PM

In those units I've used stock fans from Prommie/Vapo so Panaflo or Sunon. One added fan in "vapo LS" (now without case) is Delta if I remember well.

All fans are 120/38 mm.

Thanks

**chaotic** · 09-05-2012, 03:01 AM

I wonder if exist condenser with 180mm fans because i found this http://www.silverstonetek.com/produc...id=222&area=en and i think is very good choise 150cfm 36db