i920 Oc@3.8 are settings ok?

[hoton]

Hi.everyone just overclocked Gigabyte x58a-ud5 rev 1 @ 3.8ghz.Everything is stable. G skill @1520mhz 7-7-7-20 1T @1.6v
Running Noctua NH-U12P SE2 performance push/pull config.Temp seem ok.
Memory/ram -G.skill Trident F3-12800CL6T-6GBTD/1600 6-7-6-18 1.6v.Case-coolmaster 690 - 3x120mm rear/front/Side.
Power supply-Thermaltake toughpower Qfan 850watt active.
Graphics card-gigabyte HD5770 128-bit gddr5_850/4800 mhz.

I cannot find spread spectrum in bios settings,Has it a different name?
I have load line level set to enabled,Is level 1 any better and I have set unicore@16x is it ok or set it to auto.
Can i impove on voltages and settings.Happy with current 3.8ghz don't wont
to go higher as yet.See attached settings.The only thing I have changed is CPU EIST to
enabled( re-enabled it).didn't like it running high 3.8 ghz on idle.

Thanks Hoton

[hoton]

I forgot to add this attachment.Sorry!

[Conquistador SW]

He, welcome to XS!

It looks all fine to me. I can't answer your specific questions as I don't have a Gigabyte mobo, but if it is all stable leave it like this.
With the voltages you are using you will never run into any problems degradation wise. Temperatures are also fine.

[hoton]

He, welcome to XS!

It looks all fine to me. I can't answer your specific questions as I don't have a Gigabyte mobo, but if it is all stable leave it like this.
With the voltages you are using you will never run into any problems degradation wise. Temperatures are also fine.

I was thinking of turning of cpu EIAST(power saving)is that a goo idea.
and use clock ratio @x21 and BLK191
And seyload line callibration @ level 2?

And also set timming @ 1520mhz 6-6-6-18 1T 1.64v.
Whats you ropinion .Thanks Hoton.