I have two aquaeros, one per loop. I wanted to try out a new fan this morning so I connected it to one of the fan connectors of one of the aquaeros. So far so good. The fan didn't start, so I went into the Aquasuite to setup the fan and associate it with the ambient temp sensor.
As soon as I did that, the aquaero stopped functionning. The fan itself works normally, but the aquaero is not recognized anymore either by the Aquasuite software of the device manager.
I tried restarting, desconnecting the aquaero USB connector, desactivating and activating again the aquaero, but nothing works.
The aquaero is powered up, there is nothing unusual with it, except it doesn't work.
Not sure what to do, it doesn't look damaged in any way, it just won't be recognized
Any ideas?
Bookmarks