I had some free time today so I decided to get started on a big order I have to get out for Under the Ice . Big 18CC low temp Danfoss with sized 3/4 hp condenser. These are gonna freeze any 980X to the bone.
Big Stepper evaporator with 4ft 6in suction line for extra capacity.
Last edited by runmc; 08-18-2013 at 10:44 AM.
Nice one Ron !
nice work
any temps so far?
Thanks BillOriginally Posted by Buckeye
No time to load test right now. I'll do that in the morning and post results. -40C with 300W load would be nice for me.nice work
any temps so far?
For some reason I think you'll see that.-40C with 300W load would be nice for me.
Where'd you get the condenser :P
If you have a cooling question or concern feel free to contact me.
![Send a message via AIM to [XC] gomeler](images/misc/im_aim.gif)
I believe he, along with sdumper, are buying condensing units off eBay.
Not sure if this was a question or a remark but I figure I'd answer for the sake of others.
I should just send off all my parts and stuff to you Ron and have you make a unit for me LOL. You do such a good job
i remember asking the same question...a few times... dont remember hearing it was from ebay though.
I would have seen that one
If you have a cooling question or concern feel free to contact me.
eBay Israel -
RunMc is now in the import export side of things huh?eBay Israel -
Ron your builds are looking so professional mate
this one just looks so clean
1. The first rule of Bench Club is, you do not talk about Bench Club
2. The second rule of Bench Club is, you do not talk about Bench Club
3. If someone says stop, goes limp, taps out, the the benching is over
4. No bummers in the batcave, apart from unkie dave
5. One Bench at a time
6. No air, no water
7. Benching will go on as long as they have to
8. If this is your first night at Bench Club, you have to Bench
Quite professional indeed.
One suggestion, with this size build move to a larger non-spun filter.
It's inadequate normally with this larger style build.
If you have a cooling question or concern feel free to contact me.
But is it really? Not like he is ingesting minute traces of water from a pinholed air exchanger or from leaky schraeder valves.
It needs a case and thermometer.
outstanding expectations -)-40C with 300W load would be nice for me.
which gas do you use?
p.s. that condenser is really huge
Vacuuming is as and will always be a matter of proportions. Larger system, same amount of vac means more particulates/moisture.
If you have a cooling question or concern feel free to contact me.
Yeah but we aren't talking about adding 30 foot suction line and discharge runs with 20 feet of piping in the air handler like on an A/C unit. Whatever, trivial component to argue about.
Was just a point of improvement Chris, I've had better performance with larger filters when I have a huge condenser.
If you have a cooling question or concern feel free to contact me.
gas is r507 and the condenser is for a 3/4hp compressor, but it is beefy.
And what about the noise level? Also 'beefy'? -)
unfortunately I hven't seen any silent fans of this type yet, at least before plugging them in via 3-5 mF cap.
looking good ron
Your not going to cool 300Watts with a 120mm silent fan
Ron,
Unit looks good.
condenser/fan setup available in the US? Where?
thanks
Last edited by baker18; 02-15-2011 at 10:19 PM.
Posting Permissions
is the remedy 
Reply With Quote
Bookmarks