I have attached screenshots of my bios settings. I can't seem to get prime stable past 4.7. I have tried vcore all the way up to 1.5v but I can't prime for very long being that there's way too much heat. I see a lot of people getting 4.8 on less voltage than me. I realize every chip is different, so this may just be what I have, but I would appreciate any help you guys can suggest. Rig specs are in sig.
I haven't overclocked since q6600 so some of these settings are new to me. I was also wondering about the different levels of llc. My last board was maximus formula se and there was only enabled and disabled for llc, now there is 25%, 50%, 75%, and 100%. When people are posting that they are on a certain vcore, lets say 1.4v do they mean 1.4v in bios or 1.4v actual voltage underload with llc factored in? Should I try upping cpu pll? I haven't messed with that yet. Thank s again.
Bookmarks