2000MHz Ram - 1090T & 890FXA-UD5

[Slappa]

http://slappablog.wordpress.com/2010...xa-ud5-part-3/

another small result. managed to do another 32m run, lowered the tRAS back down to 15

still fighting with prime 95

[BeepBeep2]

http://slappablog.wordpress.com/2010...xa-ud5-part-3/

another small result. managed to do another 32m run, lowered the tRAS back down to 15

still fighting with prime 95

Nice result on those mushkins

[Slappa]

Nice result on those mushkins

Thanks man! Time to start figuring out Prime 95 since I just got home from school. Must have these speeds 100% stable

[Royalk]

Hi, Slappa can you try 300 htt with 6.66x ram multi to see if it can cold boot?

[Slappa]

Hi, Slappa can you try 300 htt with 6.66x ram multi to see if it can cold boot?

Yeah it boots, it even boots into windows.

[Royalk]

Yeah it boots, it even boots into windows.

UD5 is good...
My 890GPA-UD3H can't, the same issue on C4F, but it's fine with 8.00x multi 250MHz htt. Maybe CPU IMC's bug?

[BeepBeep2]

UD5 is good...
My 890GPA-UD3H can't, the same issue on C4F, but it's fine with 8.00x multi 250MHz htt. Maybe CPU IMC's bug?

Depends on chips as well. I think I remember chew* talking about Hyper having effects on HT Ref. after a certain point.

I'm able to do pretty high numbers on my 965...not 2000, but

[Dahaka]

Any SS of BIOS?

[Slappa]

I will get BIOS pics for you guys tonight.

But finally I am prime stable!

http://slappablog.wordpress.com/2010...-prime-stable/

[Zeus]

Nice going there Slappa. Shame on trcd 10, this is killing performance completely unfortunately. DDR2000 looks nice and shows loads of bandwidth in Everest but other than that it has nothing over DDR1600 6-6-6 unless you can run real tight timings.

Seems like you have a good cpu there.

[Slappa]

Nice going there Slappa. Shame on trcd 10, this is killing performance completely unfortunately. DDR2000 looks nice and shows loads of bandwidth in Everest but other than that it has nothing over DDR1600 6-6-6 unless you can run real tight timings.

Seems like you have a good cpu there.

I tried to run it lower. Didn't work.

I'll see what I can do to lower it back down. I still havent updated the BIOS on this board for awhile either.

Other than that I can try going back down to the 1600MHz range and try to tighten as much as possible.

[Zeus]

You could but i don't think that would make much sense, you will need a pair of Hypers to go really tight. Maybe 1800 6-7-6 is possible?

[Slappa]

You could but i don't think that would make much sense, you will need a pair of Hypers to go really tight. Maybe 1800 6-7-6 is possible?

I need to pick up some of the super talent hypers that are floating around. I hear theres some good deals