Some speed bumps but i finally finished (lots of pics)

[MasterSe7en]

ok so i had some serious issues to begin with, i started with 3 470's and an Asus R2E, 2 of the 470s went bad, so i replaced them, then i decided i wanted a new board so i went and grabbed the R3E and upgraded the cooling, got a WB for the 3rd 470, then i ran into issue after issue, so first i setup passive SLI Config and the temp on card 1 was going from 40c to 90c in about 30 seconds underload, so the water wasnt circulating properly, i dunno if i should setup a T or what but i changed back to serial, now its working perfect, however when i was switching it around i used a pair of pliers on the fitting and i broke 2 of the resistors off the card, so i found an old mobo in the closet, and boy did i get lucky, the first 2 resistors i grabbed were the right ones, so i soldered them back on and bam....worked like a charm, so ill show u guys some before and after shots

so this is Before 1, what i came to u guys with

Before 1

Before 1 ya it was a mess

Before 2(After i got the RE3) still a mess, too much hose

before 2

Before 3 (After i fixed everything up, but cooling on the GPU's was bad

Before 3

After! The Finished product, GPU2 Fixed and cooling is perfect

After


So as of now im running 4.1 on the CPU Stable, and 780/1560/1900 on the cards with a voltage of 1087(Max)

Also i have a RE2 for sale if anyone is interested
So whaddya guys think now?

[Conumdrum]

Looks pretty good

But, what liquid? And are you worried about clogging and staining?

[lowfat]

why are you using the 90 elbows? Those bends don't look bad enough to use them and they look very out of place.

[MasterSe7en]

i thought they kinda looked nice thats all, i like the way they make the system look, they give it a more complex look instead of just hoses bent in weird ways