Ok, So I'm going with 6 Swiftech quad's with 4 1850 gt's on each.
My problem is I'm trying to figure out how or what to use to wire all my fans together. I want sleek and nice looking.
The fans are .84a or 10.08 watts per at max speed, using em on a Scythe Kaze Master Ace 4 unit I can wire he fans 3 to 1 and even 4 to 1 and it works ( Koolance wiring harness's) but reports back 1650 rpm at max and I blew one of the connections.
I'm never running them at max but I have these now I know there sound Sig I like it.
There Silent under Background noise @ 1250 -1350rpm.
The only fan controller if Found that I can comfortably fit each rad on as a Single unit is the Lamptron FC-2 45w per channel.
Since its going in an Extended Ascension Mountain Mod
I need about 5 feet of Cable to run it along the edges of the case between the controller which will be mount the back bottom right corner and the front and top rads Link will give you better idea mounting FC-2 in 5/14 back
To start off I can't solder , its not going to happen. Sleeving its a possibility due to my carpal tunnel it will cost me Blood sweat and tears ... lots and lots of tears that or I might be able to bribe my wife with jewelry to do it for me.
But my big question is can anybody think or know of a better way to wire these fans up besides using 1 60cm Phoyba 3 to 4 splitters and 1 60 cm extentions per Rad set to get them attached ?.
Something like the Bit power fan power board but not as big/tacky ?
Or know anybody who makes custom fan harness cables etc ppcs all ready turned me down ?