Another MCP655/D5 Dual Top Thread

[randomhro]

I have two MCP655-B/D5 pumps in the bottom of my case that I just put in one loop and want to clean up the tubing some. Here's a picture of how it's setup now (more or less, I trimmed a lot of that connecting tube off last night):



I started looking at D5 dual tops and read up on the EK top some but I didn't see anything on the Bitspower dual top:

http://www.frozencpu.com/products/11...c107s156#blank

Someone here must have this top and know how it performs vs. the EK top. Any feedback is appreciated.

[NaeKuh]

id honestly get the EK.

IT seems like that bitspower will give you problems mounting it in a 5 1/4 bay.

I remember that Eddy had to pack the D5's very close together so it would fit.

The bitspower isnt like that, so i am assuming it WONT fit in a 5 1/4 bay.

[randomhro]

id honestly get the EK.

IT seems like that bitspower will give you problems mounting it in a 5 1/4 bay.

I remember that Eddy had to pack the D5's very close together so it would fit.

The bitspower isnt like that, so i am assuming it WONT fit in a 5 1/4 bay.

Honestly, I don't care much about fitting it into a 5.25" bay. I'm probably going to leave them where they are at the bottom of the case but just clean up the connection between the pumps with a top while being able to use G1/4 barbs.

My fingers are still sore from prying 3/8" ID tubing onto the 1/2" barbs on the stock tops of the D5's