After some time hangin around here i thougt lets post my casemod here, still building it.
I bought a secondhand LianLi v1000B plus, it was already coated black so that was a +.
When it got here after 2 days i was verry happy, Lets unwrap the mother!:coke:
Then i scared the hell out. My eyes were seeing this:
Now that says enough, some fatdude/chick have used my case as a chair.
Wtf how much weight do u need for that kinda damage to a LiLi v1000
After some calls and mails i got the green light to fix the damn thing.
So i disambled the whole mofo and start beating it up(in a good way), and i Got some good results.
Used: heater, hammer, 3clamps,piece of 4sided tube.
So lets go on then, my base was OK now and 100% in 1 line.
Thats some good progres.
After 2 days i got myself 2 HWlabs blackGT's.
1st location.
Some fancy LiLi fanconnectors for the eye side :crack:
Got myself some awesome goodie!
It look like an triangular sandingmachine,but what can he do more?
Hmm i can do some sawing with it, so lets try it on my sidepanel.
Give the sidepanel some protection and drawed my design on it.
The idea for the panel.
Than i hooked the sanding machine whith the pre-ordered sawingblade.
Thing working like hell! damn so ing straight
Otherwise, i need to file it bij hand sooooo, hmm the machine is nice but still need some elbowgrease to make it worthy.
First half is done, looks awesome-o
Not 100% but that is for some othertime, my fingers where hurting like hell.
This looks good right? (the res was a mock-up but hell no its not worthy the case like that)
Time to set rad Nr2.
Some protection/holy modderstape.
Made myself some template(look good :P)
Grabbed my FEIN again and attacked the case.
The Toy himself.
After some cleaning and filling.(the edges wil be made black again)
Pinned down.
Looks Ok for me boys!
Got the rad back in place.(whith the mockup res)
Got some lexan plate an taped it up.
Get the FEIN again WHaha.
Let the machine work
That cut to the correct size,
After some playing whith the FEIN.
Kinda rough edged
After some filling
After some sanding
Holes?
1 to-go.
Some old what im working whith.
2 holez.
Now that fits quite good!
Ripped of the tape and drilled some holes and countersink it.
Time to get the switch inplace.
After test fitting it, it fits.
Mockup.
Painted the piece black, for the pwerfect finish.
Its all done now, im verry happy whith the looks!
After these thing some time goes by, then i got some mail of 2 people/companies who wanted to sponsor me, after some dealing i went for the best deal.
the sponser is:
Got some goodies after 1 week.
The box contains:
EVGA GTX295 single pcb Bitspower black freezer VGA block.(look freaking awesome!)
EVGA classified Full cover block+mosfet black freezer.
a TFC Xchanger 120 rad.
Some fanrubbers.
Im so happy whith it u know my setup now to :P(a little).
Some better pics.
So back to the modding again.
Got myself an John Lund res and give it this place.
Give the Xchanger 1.120 rad this place:
After deep thinking(LOLZ) i have made myself a drawed loop, for the idea,
Pump is a d5+BP modkit and top.
Thats is for today.
Bookmarks