Failure "XSPC Dual Pump Acrylic Top"

[malkiewicz]

SoulsCollective,
Good luck with yours – I’m pretty fortunate because none of my hard drives died.



NaeKuh,
To answer your question I never used alcohol to clean any of my products or equipment, and I’m still waiting on a response from XSPC about the warranty.



RCG_Bex,
Your correct - I’m using a chiller but I keep the fluid temps around 15-18C (Cold Side) and the pump is located on the warm side (20-23C). It’s possible that fluctuating temperatures could cause this to crack but my temps remain fairly constant



I attached a few more pictures – All cleaned up and ready for an RMA as soon as XSPC responds to my emails... If not, can this be fixed or is anyone interested in a used / leaking acrylic top?

As you can see in the first photo it looks like the acrylic glue separated in multiple areas around the inserted piece.

[malkiewicz]

Update:

I just received an email from XSPC a few minutes ago and they offered to replace my broken acrylic top. Hopefully this is a smooth process… Has anyone else received replacement products from them before?

[NaeKuh]

You didn't start it huh? You got something to say in your defence?

This

Three words: EK dual tops!

So i said nah.. there is better...

The EK Dual Tops can have dual and even triple inlets if you screw an EK-Multioption LINK and reservoir onto them. The first two inlets are in the Multioption link. The third inlet is in the top of the attached reservoir.

Then he goes no there isnt, so i swing around my epenis afterwards!

Update:

I just received an email from XSPC a few minutes ago and they offered to replace my broken acrylic top. Hopefully this is a smooth process… Has anyone else received replacement products from them before?

Dai Jo Bu!

however in japan... it might take longer..

Dont worry... im guessing u just got unlucky with a bad seal.