ok, i got this system together and im PRETTY sure that i can use this spare 333Mhz ram i have laying around w/ my A64 3000+ on a Gigabyte K8NS Ultra-939, i know its not on their website but i have it and it says Limited Edition... its a nForce3 Ultra chipset and says it supports Dual channel DDR400+ but i dont remember if it REQUIRED DDR400 or no, im assuming no since it seems to act fine up until windows goes to load, its got 1GB of DDR333 in it right now, two different sticks of 512mb... even tried using single sticks to see if it would make it... it doesnt...
its got a CPNS9700 NT on it running at full speed w/ AS5 and temps in bios are 33C since i most likely put WAYYYYY too much AS5 on there... but its all at stock clocks, and if it required DDR400 wouldnt it crash before it could flash the WinXP load screen?
Help me figure out what in the hell im doing wrong...


Reply With Quote
Particle's First Rule of Online Technical Discussion:
Rule 1A:
Rule 2:
Rule 2A:













..........

