Until they come up with an adapter, you can just take the plastic cpu mounting bracket and slide it on top of the WW. Ceter it and screw it down with some screws into the backplate, but you need to use some heavy duty springs on the tops of the screws to get the correct pressure and if necessary use some rubber washers to create the right spacing. I use 4 rubber washers below to help support the frame and keep form overtightening, and 2 rubber washers above to create the right spacing then heavy duty springs that came with a swiftech block. Works pretty well. My idle temps are arround 26 deg. at close to 2500mhz.