It is a Koolance Block. US$72.99 from Koolance online shop.
screws and thermal pad for some other chips, e.g. VTT MOSFET
Original Heatsink
Installation completed and is working now!
It is a Koolance Block. US$72.99 from Koolance online shop.
screws and thermal pad for some other chips, e.g. VTT MOSFET
Original Heatsink
Installation completed and is working now!
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
temp comparison before and after
Very nice!
What kind of temps are you getting?
Asus Rampage Formula
Intel E8600
Kingston HyperX PC8500 (4gig)
Corsair 750 Quad BLK PSU
WD Green 2X500g Raid0 goodness
XFX 260GTX
X-Fi Extreme Music
All tucked in my ThermalTake Full Tower
Custom water cooling by me
Oh shiiii. That thing is gorgeous
Aaaauw that is so pretty !
Very very nice! I was wondering....Do you have to use the thermal pads or can you use thermal grease? I would think you would get better temps with some MX2 or something.
Nice, that is some sexy block for a a great Motherboard, congratulations
Whats is the lowest chip at the bottom cooled by the block ?
PC: Intel Core i7 920 D0 | Kingston Hyperx T1 6GB 2000Mhz 8-8-8 RAM | Foxconn Bloodrage GTI | Sapphire 4870X2 | Perc 5/i - WD 640AAKSx4 RAID0 | Asus 2014L1T | Dell 2407WFP | Lian Li G70 Silver Watercooled
WaterCooling: Q² Project by The-Fox
CPU Loop: Swiftech Apogee GTZ | Feser X-Changer 480 | Swiftech MCP655 Vario w/ DetroitAC top | EK Multioption RES 250 Rev.2 | Tygon R3603 1/2" | YL D12SL@1350RPM x4
GPU Loop: EK-FC4870 X2 Nickel | Swiftech MCR320 | Swiftech MCP655 Vario w/DetroitAC top | EK Multioption RES 150 Rev.2 | Tygon R3603 1/2" | YL D12SL@1350RPM x3
Thermal pad is for other minor chips, for X58 chips, NF-200 and South Bridge, I applied some MX2 for sure.Originally Posted by Sadasius
As you see, my loop is first go to a 4GHz i7 920 CPU and then goes to the MB waterblock, so warm water is going into it....the temperature will be expected to be a bit higher.
It is priming now, system temp = 40-41C constantly, 28(ambient temp), idle is something about 37-38C. Now I don't need to use a fan to blow the north bridge heatsink, silent!!
Last edited by TinTin; 05-05-2009 at 06:12 AM.
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
Koolance has certainly turned around lately
Freaking gorgeous.
Asus P6T, I7-920, 6gb ocz xmp, 4890, Raid 0-1 Terabyte, full watercooled - Triple Loop 5 radiators
It is priming @ 200X20
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
Any internals? I heard that water doesn't flow through the entire block, but only through the NB area.
No mosfet block? What temps are you getting on the mosfets? I went from 85+ down to mid 60s when i switched to the koolance x58 blocks.
Koolance, I take my hat off to you. Your recent stuff is da bomb.
Rig specs
CPU: i7 5960X Mobo: Asus X99 Deluxe RAM: 4x4GB G.Skill DDR4-2400 CAS-15 VGA: 2x eVGA GTX680 Superclock PSU: Corsair AX1200
Foundational Falsehoods of Creationism
which block did you use for the mosfets? the one which koolance recommends?
yea, koolance is slowly but surely gaining a foothold in the water cooling community again
BEOYTCH!!!!!!!!!!!!
mine comes in a few hours!
But yeah nice show... u beat me to it by a couple of hours!
I should be getting everything soon. I'll post internals if you guys want because im painting the plate red.
But dean personally mailed out my stuff and i lost the race in installing them.
Dean!!
Last edited by NaeKuh; 05-05-2009 at 09:14 AM.
Nadeshiko: i7 990 12GB DDR3 eVGA Classified *In Testing... Jealous?*
Miyuki: W3580 6GB DDR3 P6T-Dlx
Lind: Dual Gainestown 3.07
Sammy: Dual Yonah Sossoman cheerleader. *Sammy-> Lind.*
Its my fault.. and no im not sorry about it either.[12:37] skinnee: quit helping me procrastinate block reviews, you asshat. :p
[12:38] Naekuh: i love watching u get the firing squad on XS
are you using different 7/16" tubings? it looks like the tube connecting the CPU block to the chipset block is more clear than the other tubes. or are they all tygon? and it doesn't look like you have any kinking problem even with that tight radius bend. can you quickly measure the distance between the two barbs connecting the NB to the CPU? much thanks!
[SIGPIC][/SIGPIC]
I think no, from the block there is a X58 marked, you can look into the block inside.
I did not open the block, just hurry to install it.
Just I feel that the heat transfer from the Vtt PWM to water block is not doing very good, I still feel hot from that area.
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
Ahh ok, well I would like to see what the insides look like on this thing.
Last edited by Baleful; 05-05-2009 at 09:30 AM.
Yes, they are all tygon R3603 1/2" ID, 3/4" OD.
Because, the other tube are older. So it look the one is more clear!
About 110mm c/c
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
waiting for your internals photoBEOYTCH!!!!!!!!!!!!
mine comes in a few hours!
But yeah nice show... u beat me to it by a couple of hours!
I should be getting everything soon. I'll post internals if you guys want because im painting the plate red.
But dean personally mailed out my stuff and i lost the race in installing them.
Dean!!
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
who knew transit time to hong kong was shorter than caliBEOYTCH!!!!!!!!!!!!
mine comes in a few hours!
But yeah nice show... u beat me to it by a couple of hours!
I should be getting everything soon. I'll post internals if you guys want because im painting the plate red.
But dean personally mailed out my stuff and i lost the race in installing them.
Dean!!
who knew transit time to hong kong was shorter than cali
I once shipped a package from podunk Hudson,NH to Hong Kong
Dropped it off at 10:30am on a saturday and it was on the guys desk at 2Pm on tuesday..
Crunch with us, the XS WCG team
The XS WCG team needs your support.
A good project with good goals.
Come join us,get that warm fuzzy feeling that you've done something good for mankind.
Circles SucQ!
If your annoyed by sigs telling you to put things in your sig, then put this in your sig
Bribery won't work on me...just say NO to AT!!!
I suppose got it yesterday, I was at home, but the UPS stupid guy said my home is empty in the tracking record.....hahahaha!!who knew transit time to hong kong was shorter than cali
CPU: XEON W3540 & Gulftown Q3FE
MB: Asus Rampage III Extreme
RAM: Corsair GT2000C7 2G X 3 ADATA XPG+ 2200+ 2G X 3
SSD: Adata S596 120G
Display Card: Asus EAH 5870
WaterCooling:
Laing D5 Pump + Koolance D5 Top
Radiator: KP 120.3
CPU Block: HeatKiller 3.0 + EK full MB Block
PSU: Antec TPQ 1200W OC
Case: SilverStone TJ-07BW
well funny thing is dean placed the order for me when it wasnt even for sale yet.
lol i was stalking him, and he was stalking the delivery guy from the factory.
When the blocks came in, there was no point in rushing it cuz it would of gone out the next day and arrived next week. :\
but yeah... its funny how u got them b4 i did, and i bought them b4 they were listed for sale.
Couple more hours til ups arrives.
Lemme paint it red first, then i can stripe it black with your method if the red is too overpowering.
EDIT: UPS ARRIVED
Last edited by NaeKuh; 05-05-2009 at 11:09 AM.
Nadeshiko: i7 990 12GB DDR3 eVGA Classified *In Testing... Jealous?
Miyuki: W3580 6GB DDR3 P6T-Dlx
Lind: Dual Gainestown 3.07
Sammy: Dual Yonah Sossoman cheerleader. *Sammy-> Lind.*
Its my fault.. and no im not sorry about it either.[12:37] skinnee: quit helping me procrastinate block reviews, you asshat. :p
[12:38] Naekuh: i love watching u get the firing squad on XS
Posting Permissions
Reply With Quote
Bookmarks