good old D9JNL in a crucial value PC8500 kit
2.3v cas 6-6-6-18 1T
1840 cas 6-6-6-18 2.4v
ram is on DICE
validated
1800: http://valid.canardpc.com/show_oc.php?id=573600
good old D9JNL in a crucial value PC8500 kit
2.3v cas 6-6-6-18 1T
1840 cas 6-6-6-18 2.4v
ram is on DICE
validated
1800: http://valid.canardpc.com/show_oc.php?id=573600
Impressive stuff Which board?
Ok wheres 32m
heatware chew*
I've got no strings to hold me down.
To make me fret, or make me frown.
I had strings but now I'm free.
There are no strings on me
Yah kind of useless to me if it can't run 32m.......if it can't 32m it cant 3d....
Let me know when you find a set of budgets that can do 1720 + 6-6-5
multiple instance 32m stable and pass 3d 06 cpu test 3 times back to back
How high can you run the CPU at that speed or are you backing cpu clocks off to improve IMC stability?
heatware chew*
I've got no strings to hold me down.
To make me fret, or make me frown.
I had strings but now I'm free.
There are no strings on me
Honestly the ram is most likely not to blame, you've probably hit the IMC limit of the chip. They start freaking out at a certain speed chip dependant.
The high voltage stuff tends to lower the point they freak out at over all, limiting NB and or cpu speeds.
We are getting better speeds 32m/3d stable with elpida hypers and lower voltage, stuff is just so darn expensive and I prefer benching with 2x2g which makes the cost factor even worse.
I noticed at the event when I shifted to my low volt 2x2g OCZ's I was able to squeeze another 50 mhz out of the cpu 3d stable, preety much already knew that would happen as i've duplicated this numerous times.
Last edited by chew*; 05-25-2009 at 12:43 PM.
heatware chew*
I've got no strings to hold me down.
To make me fret, or make me frown.
I had strings but now I'm free.
There are no strings on me
that vdimm is way too high for jnl to be stable, the highest stable vdimm ive seen on jnl was 2.1v
well that was on air though...
running this high vdimm will degrade and possibly kill the mem chips on jnl in my experience...
Could you upload some cinebench R10 scores, pls?
Bookmarks