i took another look at the datasheet and its right there.. i looked too hard and didnt see it!
- the lower the resistance at this resistor the higher the vcore allowed
- vid 1/2/3/4/5/11 bridged.. pencil this resistor to bring resistance down to around 350ohm
1.33vcore @ load
or
- this point increases vcore according to the resistor in above pic ^
- vid 1/2/3/4/5/11 bridged.. solder a 150ohm resistor to ground from this red point
1.33vcore @ load
pencil + 150ohm resistor = 1.36vcore @ load
cryptik if you want to confirm .. and look at the vdiff pin @ datasheet
Bookmarks