Corsair Dominator 2x1GB DDR2-1142 $79.99@NewEgg

[Shiranui Gen-An]

http://www.newegg.com/Product/Produc...82E16820145169

As far as I know, the only revision of these was 1.x which makes them Micron RevD chips. Good buy for any people still hunting down memory with D9GMH/D9GKX ICs.

[trapezoid]

Something that a lot of people may still need actually! Good post!

[Lestat]

yeah those things were so freakin picky about what board you put them in.
most of the time they wouldnt even boot because they done have an SPD of , say 800mhz 5-5-5 at 1.8v.
so you end up swapping ram around to make them boot at a higher mhz and voltage.
oh and if your overclock fails,, your screwed if the bios reverts back to defaults.

i had a set of the 8888's and they were crap,,, wouldnt even run stock.
yet my gskill 6400hz's would run fine 1200mhz 5-5-5-15 2.23v....

i hate installing this ram too, those god dam razor blades they put for heatsink fins are retarded... they are a to install.

[zanzabar]

those have a power chips REV, dosnt look like d9 to me with the 2.1V ether

also the d9 have a 1024 name the powerchips have a 2048 name
CM2X1024-9136C5D
........................XMS9136 v1.X...MICRON.........64Mx8...Rev.D

CM2X2048-9136C5D
........................XMS9136 v1.X....PSC............128Mx8
http://www.houseofhelp.com/v3/showthread.php?t=57334

newegg has the latter

[noinimod]

i'ld rather pick up some gskills.. seems like they have less compatibility issues compared to the dominator

[jonspd]

i'ld rather pick up some gskills..

quote FTW I ran my 2gbhz in like 4 different board without one issue...