First hour no errors

[ShawnTRD]

Hows my Voltage and Temps look?
Last night I was running OCCT and had a "Error 1" within the first hour. Now I've bumped my CPU, NB and Terminal Voltages up just one or two spots. So far no problems.

ASUS Maximus RAMPAGE 0308 BIOS
Intel Core 2 Duo E8500 400 X AUTO (6X-9.5X)
Crucial Ballistix 4GB (4 x 1GB) DDR2 800 (Running at 1066)

[ShawnTRD]

Failed with 40 minutes left

[unclewebb]

Why not run your memory 1:1 until you find out what your CPU is capable of. 450 x 9.0 with your memory at DDR2-900 CL4 is a good place to start with Ballistix. With a little more core voltage many E8500 C0 can run 450 x 9.5 reliably for a nice 24/7 overclock. Don't push your memory too hard until you've found a happy spot for your E8500.

[ShawnTRD]

Why not run your memory 1:1 until you find out what your CPU is capable of. 450 x 9.0 with your memory at DDR2-900 CL4 is a good place to start with Ballistix. With a little more core voltage many E8500 C0 can run 450 x 9.5 reliably for a nice 24/7 overclock. Don't push your memory too hard until you've found a happy spot for your E8500.

I can't seem to get my CPU much over 410 X 9.5 when doing 1:1. But I might need more Volts

[Zigosity]

You can go higher on the CPU if you need to. Maybe bump down the NB a little bit, it doesn't usually need to be that high. What's your PLL at?

-Zigosity

[ShawnTRD]

You can go higher on the CPU if you need to. Maybe bump down the NB a little bit, it doesn't usually need to be that high. What's your PLL at?

-Zigosity

I've always left it at the lowest setting of 1.50

[ShawnTRD]

Should I boost up my PLL some?