G.skill 1600mhz DDR3 hz's

[mpower1001]

I have the G.skill F3-12800CL7D-2GBHZ and they are installed in a EVGA 790i, i was just wondering what is the default command rate for these modules, my board sets them to 2t, and i was wondering if they will do 1t. Thanks

[GSKILL TECH]

we use Auto 2T to test. what bios rev you use? i use p04 and give me a lot of problem.....

[M.Beier]

I would recommend you to increase vmch if you get instability from 1T, as its not ram related, but IMC, or in your case, NB related...

vNB = Voltage NorthBridge
vmch = Voltage memory Controller Hub

I dont think you will see any change it the frequency of the ram, but, you have to realise your adding alot of pressure on your motherboard when using 1T.

[camouflage]

You can run them easily 1T on a good mobo:

[extremis]

No matter what I do, I cannot get vista to boot without bluescreening when using the G.Skill 2x2GB DDR3-12800 7-7-7-18 RAM. If I use 1 stick, everything is 100% stable. Once I add 2 sticks, bluescreen all the time.

Has anyone gotten this combo to work?

Do I need to return this RAM for something differrent?

[mpower1001]

You can run them easily 1T on a good mobo:

Thanks... they do run fine at 1T, what voltage are you running at those settings.

[M.Beier]

No matter what I do, I cannot get vista to boot without bluescreening when using the G.Skill 2x2GB DDR3-12800 7-7-7-18 RAM. If I use 1 stick, everything is 100% stable. Once I add 2 sticks, bluescreen all the time.

Has anyone gotten this combo to work?

Do I need to return this RAM for something differrent?

Too much load on memory controller - try doing what I wrote previously