Th[E] Pot....

[Ad1tya]

Yeah well, im from Team Erodov so.. Lol..

Well, heres my first pot..

My first DI / LN2 Pot! ..






Cost me a whopping Rs.5100 (~120$?) for the Copper.

This thing weighs 4KG. (Bored out of a 10KG Block of copper!.. Omg, all that waste copper ... Who cares? :p)

:ola:

In Action..






I think it was a good pot, if not really good. Got us down below 131C, and gave us the cold boot issue! .
Also, it maintained temp. with LN2 at a steady 100C as well, it wasnt fluctuating a lot.

Base from the extrusion to inner base is about 18mm thick.

Regards,
Ad1tya
Team [E]rodov

[KiD0M4N]

had fun benching on the pot. The ln 2 temps got a little too chilly for my and the motherboards comfort.

The moment when the pot almost consumed a full fill of ln2 in like 5 seconds was awesome.

[Buckeye]

Looks Great and thanks for the photos !

Just a dumb question, but can you gather up all the copper shavings from when you machine those tubes and recycle them ?

[Ad1tya]

No idea ^^.
Although, I dont see why not :P.

Any LN2/DI Pot Guru's here to comment on the design?

[Cupcake]

Looks good