E8500 Q740A645 + Commando

[c1rcu1tburn3r]

Hi all...this evening i tried my E8500 on some spi and pifast scores.
My setup is always the same, but i'd only 1 stick of DDR2 then i'm limited with results, anyway i'll try to do better when i'll have new memories :

E8500 L740A645 @ 1.84v
Asus Commando rev C2 - Vcore, vdrop
1024 Cellshock Red Passion 9200 @ 2.65v
Ocz Powerstream 520W
Ati x1050
Cpu @ -114°C (Little Devil`s Pot)
Nb @ -25°C (Homemade)
Bench Table by Dimastech.it
Boot 550x9.5

Spi 1M 8.250s



Pifast 17.49s



I hope to do better soon

[andre X_X]

nice run bro... anyway do u use strap tweak for the run??

[Polizei]

How does it get better with an E8500?

Nicely done.

[loopy83]

Nice result vor CL5....

plz can you post your voltages?

[Viss]

Nice start. Have you tried max FSB with lower multi? Curious how much you gain by chilling the NB. Youd think the ram should do cas 4 at those clocks and volts. Single channel only makes a very very small difference compared to dual in 1M.

[c1rcu1tburn3r]

nice run bro... anyway do u use strap tweak for the run??

Thanks! Yes, but i've to optimize it... anyway my OS isn't perfect couse i encountered some problems during installation (vga drivers and some other issue)

How does it get better with an E8500?

Nicely done.

Thanks, i think i can do better !!!

Nice result vor CL5....

plz can you post your voltages?

vcore 1.84
vdimm 2.65
vfsb 1.50
vnb 1.75 (not change with more)
vsb auto

Nice start. Have you tried max FSB with lower multi? Curious how much you gain by chilling the NB. Youd think the ram should do cas 4 at those clocks and volts. Single channel only makes a very very small difference compared to dual in 1M.

I've not tried with E8500 for max fsb,i forgot it. But i tried with my E8400. My commando is pretty good and it run on air cooled chipset till 645mhz. Chilling it i achieved 660Mhz on E8400 and i think is one of the highest fsb done with a wolfie.
You're right with my ram cas! But this stick is at his end,his brother is dead , some months ago i could run without problem this freq @ cas4...but now...i'm searching a good pair and we'll see if i can do better!

[MARCO74]

nice chip my friends....

[c1rcu1tburn3r]

Thanks Marco, i bought some ddr2, we'll se again what i can do at those freq but 2Gb cas 4-4-4-8 and tight sub
I'll try also some bench with my E8400...

[BlueAqua]

Nice stuff, but I think there is more in it!

Where was that Commando made? Taiwan or China?

[c1rcu1tburn3r]

China, all my mobos are made in china,if not i don't buy it
I think that for this settings is difficult achieve better scores, btw we'll see also with another commando,maybe this have some problems with memories...
What do you think?