Well he has problems existing so let it warm up at defaults for a while and see if there is any noticeable issues then go into seeing if problem still exists at what the settings were that were giving issues.
I always let my PC warm up at optimized defaults for a while after flashing plus the new Bios if you run the .EXE Package the entire top row of blocks DO NOT get Updated and that may have been my issue on that Bios so I gave him the switching Parameters along with the /F Switch and it should have written all this time minus a couple on the top row when programming and by doing it twice allows for cleaner flash and better chance of over writing the old properly.
So we will see what happens.............................
Bookmarks