-
The Sticky TEC section!
All the stickies in one section.
The Ultimate Guide to TECs (must read for new people)
http://www.xtremesystems.org/forums/...ad.php?t=38367
Socket 775 Insulation guide
http://www.wintschlabs.com/ArcticWeb...75Install.html
The wintsch Labs web site has finally been closed down so the insulation guide no longer works. But if you look in the phase section here. http://www.xtremesystems.org/forums/...d.php?t=104456 you will see several very nice guides. They insulate the same way we do with TEC. I for one really like Silencer's guide.
Here is a new nice guide for insulating for a tec. also there is a link for the new eraser way to insulate
http://www.xtremesystems.org/forums/...d.php?t=207427
TEC undervolting charts
http://www.xtremesystems.org/forums/...ad.php?t=67927
Guide to changing the MCW50-T pelt
http://www.xtremesystems.org/forums/...ad.php?t=20335
swiftech have updated their unit and a lot of what was said is really no longer relevent. In this thread. But it still gives some in site.
The "What power supply can be used for my TEC" thread
http://www.xtremesystems.org/forums/...ad.php?t=28294
Last edited by littleowl; 11-13-2008 at 05:03 PM.
-
Powering a TEC
Please read and remember when dealing with a TEC!!!
If you put a tec on a PC PSU your risking a fire because the wires are not able to handle the current the tec will draw. The wires on the tec are the same size when looking at them but they are tighter strands and many many more strands for each wire.
PCP & C even states that there single +12v rail with 60A capable should not run a tec without cutting 6 12v lines and splicing them to the tec as well as 6 ground lines.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks