MousePot 4.1a GPU plans

[K404]

Posted with the permission of Jason. His words:

First rev4.1a
Note the 1.2in x 1.2in extrusion can be .025in thickness .05in is not needed for 2900xt inside shim install

Please share
You do not have to say a Mousepot Clone if you copy the deisgn
Ill try and do a MM format and CM format, but for now just Inch format

Print out at 200% at Kinco's and take to machineshop for manuf.

Thanks for helping expand the evolution on pot deisgn

[massman]

Thanks Jason, this kind of sharing makes the community better.

[T_M]

Thanks for sharing your hardwork Jason.

[ent]

Thx for sharing Jason!

[Extera]

Wow, that's a hell of a lot better then the drawings I posted a few days ago.
Thanks a lot!

here are messurements in MM. I recalculated them 2 decimal after the . witch is a bit overdone I think. Anyway, here it is.



Only problem is finding a drill of that size I think. Maby Jason needs to adjust some more.

[Stapler]

^Those are the pots Kinc is using, so the drill size must not be a problem.

[BeardyMan]

cool with some slight modifications you can get more mass out of this design, nice