Well lets go where no one has gone before.
The insides of a prommy..
As some of you all ready know, I have recieved OPPAINTER's prommy to repair and mod.
I recieved it a day ago.his had broked the capillary tubing off at the cooling head ( evaperator ).
the first thing i am doing is repair and upgrade the unit. so i have ordered new capillary tubing and am going to try and replace the flexable tube chip-con uses to allow the head to move easily.
i have been taking full dig pics of the tear down and will start posting later tonight.
I am replacing the refigerant with r404a and adjusting the capillary tubing to handle the differance.
I know a few have moded theres and changed out the gas,but without the change of capillary tubing there is no way to fully get the benifet of the r404a.
and since his broke right at the evap head i will have to un brase the cooling head so we will get to see the insides.
before i get pm's out the rear about doing this mod....let me say this is not a cheap mod to do.there will be alot of time doing the final adjustments.and it is not for everyone.to do this mod you will need to be very very good with refrigerant systems.replacing the capillary tubing is really hard to do on the unit.
I was not sure about posting this until i recieved the ok from OPPAINTER himself.as this belongs to him ... he had the final say over posting or not.but he granted me the posting right.
so thanks OPPAINTER and i will see if we can set a few more records...temp wise that is.
i will begin posting pics tonight after i get home.....
Bookmarks