well, I was going to offer you clearing cmos - which in the first place fixed my problem (my optical drive detected).
1) Now, first disconnect ur sata drives.
2) Put your optical drive's jumper to cs (cable select)
3) Clear your cmos again - in case (as you did before: unplug, remove battery, change jumper, put jumper back, put battery back, plug it)
4) Press delete while booting up.
5) in the bios, under on board settings make sure that 'jmicron' is enabled and set to 'ide'
6) save and reboot - it should detect...
Hopefully
After it detects, for your sata drives:
1) if you would like to use them as your master drive, connect them to pink slots. Otherwise put your optical drive's jumper to 'master' and connect your sata drives to black ones.
2) if i were you i would try with only 1 sata drive and the optical drive initially (given that you solved the ide problem)
Hope it helps...
Bookmarks