First of all I want to say that the following tweaks are a composite of a lot of dedicated overclockers tweaks …bye NO means are they all my original ideas ! Over the years I have compiled a fairly large database of clockers that I respect and mix and match THEIR ideas to come up with this guide. I scour the various overclocking forums to pick up information and listen in on various ideas and try them out for myself. Some but not all of the guys whose ideas went into this guide are as follows, Macci, Gibbo, Digital Jesus, Chromozone, Mr Natural, Green Beret, the chillblast Borg and a lot more if I left you out I am sorry…but I do thank all for their input and help over the years.
Following OS tweaks are for Windows 98se and Me and Nvidea Cards.
First and foremost know your system, you should have a clean fresh install of your os, and all the latest drivers, Via 4 in 1, Direct X 8.1. Fresh clean install of all VGA drivers. Check out the system and make sure all is well , then Defrag.
Run a baseline benchmark and publish it for future reference.
Set typical role of computer to NETWORK SERVER.
Set Virtual memory to ½ of your system memory minimum
Set maximum to 2 times your system memory
Install Cacheman utility, Turn on “conservative file swap usage”
On the cache tab use the following values:
32MB:
Min: 6144
Max: 6144
64MB:
Min: 12288
Max: 12288
128MB:
Min: 25600
Max: 25600
256MB:
Min: 51200
Max: 51200
Open up system .inf file I notepad and add the following line under the {386EnH} section,ConservativeSwapfileUsage=1
Using notepad again, edit your config.sys file: Enter REM in front of all lines/entries.
Now enter [b] Stacks=0,0 on a new line
Open up Autoexec.bat file and add REM in front of every line.
Now go to START, select RUN, and type msconfig, go to startup tab and click on, Untick all the boxes except explorer and systray.
Right click my computer, select Trouble Shooting and disable System Restore.
Disable power savings in windows
Disable System Scheduler
Disable features in display properties to enhance image quality : like “show icons using all possible colors.
Have very few icons on desktop
Run clean disk
Run scan disk
Run defrag disk
Install RivaTuner or NVMAX…the following tweaks are for RivaTuner.
Open up RivaTuner: Select the tab that says Graphics card click on this.
Click on enable hardware overclocking…move up by 10 and test and apply (ex 220/460 stock go 230/470) now run a second benchmark to make sure everthing is ok, score will increase.
In RivaTuner Under Power Users Section enable mipmaps
In RivaTuner under DirectX, under Textures,set amount of RAM for PCI textures to 0
Enable 8-bit palettized textures.
Set Degree of anistrophy to “force level 0 (off use nearest point)
Disable Vsync
Enable Side band addressing
Set Lod Bias Range to 15
Then go into DirectX section and set the following values.
Car Chase – 10.0
Dragothic – 12.0
Lobby – 4.0
Nature – 3.1
Under Display set resolution at madonion default of 1024x768x32
Change refresh rate to 60hz
Run scan disk
Run Defrag
Run another benchmark score will increase
Shutdown , restart go into Bios and set your memory timings
Cas2-2-2
4 Way Bank Interweave
1t Command rate
Enable fast writes &
Side Band addressing
Note real power users KNOW their Bio’s setting better than Motherboard manufacturer's
They follow forums for latest issues and Bio’s flashes and know their Bio’s inside out and try all types of Very aggressive memory settings for that you have to research your motherboards strengths and weakness on various overclocking forums and YOU must have high quality ram and cooling.
The next tweak is to raise your FSB up as high as possible and remain stable it has been my experience that a higher FSB raises scores and FPS better than anything with exception of overclocking Graphics card… In other words 10 x 150fsb is faster than 11.5 x 130fsb even though they both = 1500 Mhz
Once you find out where your fsb is maxed out and stable go back and run another benchmark. Your score will increase, now go back and overclock your card in small increments and keep running benchmarks , your scores will keep increasing …until you start getting a load of artifacts back it down and there you are. Can you go faster still? YES with better graphiccard cooling,ram cooling and of course cpu cooling …but that’s for next time :-)
Now the disclaimer you do all the above Tweaks and tips at your own risk , No one is LIABLE but YOU…. I know other people who benchmark DON’T do things in this order and don’t defrag etc as much as I do but this method works for me…….. take care and enjoy………Bulldog
Bookmarks