h2o help

[JBELL]

ok guys I did it and bought the SOYO KT333 DRAGON ULTRA


and installing it into my water case which I already posted in here...

what do I need to do to fill and bleed the lines?

[DaGooch]

A large temporary resevoir or a fill and bleed valving system like Swiftech sells.

[JBELL]

Originally posted by DaGoochMeister
A large temporary resevoir or a fill and bleed valving system like Swiftech sells.

how fast can you send me a fill and bleed?


and say 4-5 feet minimum of swiftech grade tubing

[Silversink]

You really dont need a resevoir, I never used one as they are pretty much useless unless your pump isn't capable of running Inline.


Just make a fill line like this:

[JBELL]

i am up and running after cpu fan sensor scare and bad video card...

[JBELL]

whats yoru temps???

I am getting 33c/43c with maze2 block

[Silversink]

Originally posted by JBELL
whats yoru temps???

I am getting 33c/43c with maze2 block

P4 1.8a @2.4 temps at full load 36*c (new air filter dropped temps 2*) Used to run 38*full load

Maze2 P4 Eheim 1250/ Inline Standard heater core

(Oh yah these temps are with fans at 50% and barely audible, temps drop lower but I like a silent pc/ Water temps are 27.7* ambient is 24

[DaGooch]

Nice radiator setup there SilverSink. JBell, a resevoir usually just promotes much quicker evaporation from your system compared to a closed loop system with a good inline pump.

[Silversink]

Originally posted by DaGoochMeister
Nice radiator setup there SilverSink. JBell, a resevoir usually just promotes much quicker evaporation from your system compared to a closed loop system with a good inline pump.

Damn right thats a nice radiator.....thing is its not mine, thats Hoots from Oc.com. It was just a good pic I had to explain the lack of not needing a resevoir.

My setup is similiar, except i have a Eheim 1250 and use a loop to cool my Northbridge....But I gotta admit Hoots Shroud is pretty sweet.

[DaGooch]

Yes, the shroud and the dual 120mm fan setup is pretty sweet.

[gone_fishin]

Originally posted by Silversink



P4 1.8a @2.4 temps at full load 36*c (new air filter dropped temps 2*) Used to run 38*full load

Maze2 P4 Eheim 1250/ Inline Standard heater core

(Oh yah these temps are with fans at 50% and barely audible, temps drop lower but I like a silent pc/ Water temps are 27.7* ambient is 24

Hi Silversink, I have a question because I am running 2.4 at this moment with 38C load temps at 24C ambient. Just for my own comparison sake, what voltage do you run at? I need 1.79v with my 1.6A.
Thanks.

[Hardass]

Welcome to Xtreme hope you stay awhile.

[JAWS]

Yo Gone Fishin Welcome aboard!

[gone_fishin]

Thanks for the welcome, I'll be stickin around