Achieved my goal
E6600ES on Bad Axe Rev 304
CPU cooled by XP90C
CF on watercooling
2x1024 Gskill 6400 HZ (5400 UL arriving
CPU @ 427x9 = 3.843 Mhz (424x9 for Nat)
CF @ 760 / 855 (755/846 for Nat)
DDR2 @ 2,2V
Next: cpu cooled by XKimo and mods on the board while 6800 doesn´t arrive
Very nice score ojdr.
Let's see what you're going to get with more cooling and the UL sticks.
ojdr2001 IS THE MAN!!!
Doing on a AC chip what manny cant do with one with PhaseChange..
heheh
Keep it going my friend
Thats pretty impressive for air.
My watercooling experience
Water
Scythe Gentle Typhoons 120mm 1850RPM
Thermochill PA120.3 Radiator
Enzotech Sapphire Rev.A CPU Block
Laing DDC 3.2
XSPC Dual Pump Reservoir
Primochill Pro LRT Red 1/2"
Bitspower fittings + water temp sensor
Rig
E8400 | 4GB HyperX PC8500 | Corsair HX620W | ATI HD4870 512MB
I see what I see, and you see what you see. I can't make you see what I see, but I can tell you what I see is not what you see. Truth is, we see what we want to see, and what we want to see is what those around us see. And what we don't see is... well, conspiracies.
E6600 Air cooled - 70 k done = Balls to the Wall Rock On
E8400 @ 3.84Ghz 1.25v LOAD
ABIT IP35 PRO
4 GB G.SKILL F2-8000CL5D-4GBPQ
EVGA 8800 ULTRA 660/1110
PC POWER & COOLING 750 QUAD
THERMALRIGHT ULTRA 120 EXTREME
2 X SEAGATE BARRACUDA ES.2 ST3250310NS 250GB RAID 0
We might see 80-90K very soon
...
Nice run ojdr, 70k on air was my target too with GTX's. The CF setup seems a little more powerful though (i have higher clocks and just 1K advantage).
Last edited by Micutzu; 07-04-2006 at 02:47 AM.
Very nice Micutzu. You have a killing nature...
What board and RAM did you use?
What cooling on cpu and GPU?
I assume you have used 2x7900gtx2, right?
- Bad Axe
- Teamgroup D9 2X1GB DDR800
- Scythe Ninja on CPU, stock on VGA
- two EVGA 7900GTX in SLI ... very strong cards i must admit, 1.68V/2.28V on GPU/MEM and they clock very very well on plain air.
Running CPU under phase right now, but there are some problems i need to solve. Nature benefits from CPU clock as well.
Last edited by Micutzu; 07-04-2006 at 01:14 PM.
congrats ojdr2001,
the score is just amazing. keep going. now with mb mods and "real" cooling
AMD Opteron 146 cabye 0540fpbw @ 3.0ghz 1.5v' DFI nF4 SLI-DR 623-2' 2x512 Redline 4000 ' XFX 7900Gt ' 2xHitachi 80gb Sata II raid0 ' Ocz Powerstream 520w ' Thermalright XP120 w/sx 2 and delta 190cfm
As always the master strikes back .
Congrats for the monster score
what timmings where you using Ojdr ? with the 5400ul you are going to rase that score by a lot
ihih :PNext: cpu cooled by XKimo and mods on the board while 6800 doesn´t arrive
Last edited by |-jokker-|; 07-04-2006 at 04:48 AM.
Volts?Originally Posted by Micutzu
2GB 550 3-3-3
...
Might be the Bad Axe bug, when I run 1333 strap and 4:5 divisor I get 1:1 instead of the 4:5 that CPU-Z reads.Volts?
2GB 550 3-3-3
Great scores - the "air" bar just keeps getting higher!
Thats a nice score. Your timings are much better and your FSB is much higher too. Timings are big with 01.
My watercooling experience
Water
Scythe Gentle Typhoons 120mm 1850RPM
Thermochill PA120.3 Radiator
Enzotech Sapphire Rev.A CPU Block
Laing DDC 3.2
XSPC Dual Pump Reservoir
Primochill Pro LRT Red 1/2"
Bitspower fittings + water temp sensor
Rig
E8400 | 4GB HyperX PC8500 | Corsair HX620W | ATI HD4870 512MB
I see what I see, and you see what you see. I can't make you see what I see, but I can tell you what I see is not what you see. Truth is, we see what we want to see, and what we want to see is what those around us see. And what we don't see is... well, conspiracies.
Ăłtimos resultados ojdr2001!
2.6V, but it's the Bad Axe FSB1333 bug.Volts?
2GB 550 3-3-3
very impressive results especially for air
DFI LANPARTY UT nF4 Ultra-D [6/23 BIOS]
AMD Opteron 148 [CAB2E 0546GPMW] [257x11.0 @ v1.500] & Zalman CNPS7000B-CU
OCZ EL Platinum Rev. 2 2x512[207FSB @ 2-3-3-6 @ v2.80 1T]
DFI Ultra-D [6/23 BIOS]
eVGA 7800GT [470 / 1100]
Western Digital Caviar SE 250GB Serial ATA
Antec SmartPower 2.0 SP-500 ATX12V 500W Power Supply
For some reason, I am only seeing 69960 as the highest score on the orb! I think the orb needs to be updated to accept scores as high as 99999 then updated again when someone breaks 100k! If conroe can do 4GHz on air and break 70k with two high end gpus, just imagine what itll do with dry ice for the cpu and gpu!
3000+ Venice 240x9=2.16GHz(ondie controller limit) 2x512mb patriot tccd ram
9700pro at 325/310 runs all games buttery smooth!
9700(8 pipe softmod, 128m) at 410/325 23821 at 325/310 21287 at 275/270 19159
9500(4 pipes, 128m) at 420/330 18454 at 275/270 13319
9500(8 pipe softmod, 64m) at 390/310 19201 at 275/270 16052
9500(4 pipes, 64m) at 400/310 16215 at 275/270 12560
3dmark scores with Ti4200 and Ti4800se
Ti4200 at 340/730 19558 at 300/650 18032 at 275/550 16494 at 250/500 15295
3dmark scores with older gpus
Ti500 at 275/620 14588 Ti200 at 260/540 13557 MX440 at 380/680 11551
heh what to say...You guys ROX
Core Quad Q9300
ASUS P5Q-PRO
4GB RAM
Ati Radeon 4890
Enermax Liberty 620w
Howcome theres none of those 70k scores published on the orb?
3000+ Venice 240x9=2.16GHz(ondie controller limit) 2x512mb patriot tccd ram
9700pro at 325/310 runs all games buttery smooth!
9700(8 pipe softmod, 128m) at 410/325 23821 at 325/310 21287 at 275/270 19159
9500(4 pipes, 128m) at 420/330 18454 at 275/270 13319
9500(8 pipe softmod, 64m) at 390/310 19201 at 275/270 16052
9500(4 pipes, 64m) at 400/310 16215 at 275/270 12560
3dmark scores with Ti4200 and Ti4800se
Ti4200 at 340/730 19558 at 300/650 18032 at 275/550 16494 at 250/500 15295
3dmark scores with older gpus
Ti500 at 275/620 14588 Ti200 at 260/540 13557 MX440 at 380/680 11551
Dude, the 3dMark 2001 ORB is closed..
Conroe is not yet offically recognised by futuremmark as it has yet to be released - therefore all scores are classed as unofficial - don't shoot the messenger!!
All scores will have to be re-submitted after FM release the ORB to accept CONROE entries.
And yes I believe all support for 3dm01 has been closed by futuremark, which is a real shame.
Mav
The orb is not closed except to Conroe. 3dmark 2001 isnt supported but the orb isnt going anywhere. Once Conroe is released, we will see tons of 70k scores
3000+ Venice 240x9=2.16GHz(ondie controller limit) 2x512mb patriot tccd ram
9700pro at 325/310 runs all games buttery smooth!
9700(8 pipe softmod, 128m) at 410/325 23821 at 325/310 21287 at 275/270 19159
9500(4 pipes, 128m) at 420/330 18454 at 275/270 13319
9500(8 pipe softmod, 64m) at 390/310 19201 at 275/270 16052
9500(4 pipes, 64m) at 400/310 16215 at 275/270 12560
3dmark scores with Ti4200 and Ti4800se
Ti4200 at 340/730 19558 at 300/650 18032 at 275/550 16494 at 250/500 15295
3dmark scores with older gpus
Ti500 at 275/620 14588 Ti200 at 260/540 13557 MX440 at 380/680 11551
And sooner or later 80s will be popping up left and right :P
Sweet results, and air at that, these babies are monsters..
Join the XS WCG team and do your part to help save the world..
^^^Click here to start folding for the soon to be number one team in the world..^^^
Main rig: Gigabyte DS3/6300@3.2 7950 GX2/Server:Expert/165@2.9/PCI vid/Wifes:ASrock Dual SATA2/3800@2.4/X800XTAIW/Kids:165@2.7/X850XTPE
"A computer beat me in chess, but it was no match when it came to kickboxing"
-Emo Philips
Posting Permissions
Reply With Quote
Bookmarks