There still seems to be some confusion about the voltage mods for this board. I hear the vcore is just like the KXY board but then I here that wont work. Help!! need more voltage!
has anybody got a vcore volt mod working for NF7
There still seems to be some confusion about the voltage mods for this board. I hear the vcore is just like the KXY board but then I here that wont work. Help!! need more voltage!
its the same as the kx7 7pin on the vcore chip. Altho the board has a form of over voltage protection that kicks in around 1.9~1.95 so its not worth it to mod the board really.
better off getting a rev1.2
Originally posted by Dissolved
its the same as the kx7 7pin on the vcore chip. Altho the board has a form of over voltage protection that kicks in around 1.9~1.95 so its not worth it to mod the board really.
better off getting a rev1.2
Have you acutely done it with this board. As I said I heard from some it wont work at all. However I know even 1.9 would help to get a littel higher FSB.
some other people have done ti and it works...just pin7
Intel Q9550 @ 4.1ghz
Gigabyte EP45-UD3R
XFX 4890 1GB
4GB OCZ DDR2-1066
Corsair TX650
i have a 50 ohm vr connected to pin 7 and i run it all the time gives me 1.9 when bios is set to 1.85 helps the undervolt problem can do 1.97 but if it goes to 2.01 board shuts down there is no overvolt mod as of yet and probly will never be one
oh without the mod i get 220x10 stable with 220x11 so its all good
You know I sould be able to get a FSB higher than 208 and run 3dmark2001. But I cant get above 208. I have tryed with 11, 10.5,and 10 mutiplires all not above 208.
I have all voltages high max , mem, chipset, vcore.
I have tryed diferrent memory timings.
I have a 2700+ cut
corsiar 3500
watercooling
but I have a crappy video card gf4 mx440
is it the card or what do you think?
Posting Permissions
Reply With Quote