I am already using cbrom to remove 8.0 rom and replace it with 8.5. After this version Intel roms are no longer 64kb in size but bigger. Even though I can add the rom (ie version 9.x) to the bios,...
Type: Posts; User: hadji_a; Keyword(s):
I am already using cbrom to remove 8.0 rom and replace it with 8.5. After this version Intel roms are no longer 64kb in size but bigger. Even though I can add the rom (ie version 9.x) to the bios,...
The classified is using an award bios, much easier for the ami-bios using boards.
The highest version rom I have successfully replaced in the bios is 8.5.0.1030 (I own a 760 classified). Anything higher than that gives a "pnp bios not found" error when switching the controller to...
Give hdderase a go first.
Also there is a firmware upgrade (090508) floating around from companies other than OCZ that practically eliminates stuttering on the jmcron controllers.
Very much appreciated, thx.
can someone share the UTX58_A08 bios? (rs link is a no go).
Thx in advance.
I will and report back.
x64. The upgrade was from 7068.
Thx for the heads up eva! I have taken a look at the thread over at i4memory and tried all of the suggestions but unfortunately I am stuck at 12. I have also given i7turbo tool a go that unclewebb...
I have a problem getting the 21 multi to work in win7 7100 x64. I have eist and turbo enabled in the bios (4/28) but only seem to get 12 multi (as shown in cpuz and confirmed by results from various...
I have the exact same issue. Using a lt-x38 as well. So this seems to be a problem specific to the lt-x38 (since all models of x48s seem to be able to keep ds/dds values)
When overclocking, whenever i change DS and DDS value, they always revert back to 8 (both of them) on save and exit. Anybody else notice this?
initial testing with ddr3 @ 3600 for a quick compare.
if you are using the psu in your sig (not a psu issue), I would suggest giving your Sb voltage a small increase.
giving 2:3 a go on the 965-s
for the 12.xx category
dfi 965-s
Hello
I would like to ask if anybody has tried the Q6800 on the dfi 965-s.
The bios only shows 2 cpus (and does not show the cpu as Q6800 but only as a Quad cpu). This is with the latest bios dated...
for the 14.xx category
for the 15.xx category.
This is what i have done:
1.dos flash to original using /py /sn /cd /cp /cc
2.enter bios set all options in cpu menu to disable, set jmicron to raid.
3.a.boot to windows , flash to b06 using...
I have followed your instructions (dos flash to original , then flashed with flashmenu with all options enabled as well as disabled to b06) , but I still cannot manipulate the multi through the bios...
on single stage, 1,7v, not a very good cpu...
Thx. This results are straight boot from bios, since I havent found any other software (besides guru) that can change the fsb (neither clogkgen nor setfsb worked).
Thx again for the excellent...
Thx :) I will give the 2:3 divider a go and see if I can shave a few more secs off.( this board is quite faster than the p5b......)
Thank you very much for the reply. The problem is deeper, as...
I have received a quadgt 2 days ago , and I must say I am very pleased with the memory performance on this board!
I have also run into a couple of problems. I have flashed the b06 bios in order to...