I was almost finished and the suddenly the knife hit the core and a piece got off the core. bad luck. maybe I wasnt being patient enough.
Type: Posts; User: mbm; Keyword(s):
I was almost finished and the suddenly the knife hit the core and a piece got off the core. bad luck. maybe I wasnt being patient enough.
but I dont
No offence but dont know what you mean?
just ruined my 3400+ newcastle ....Very bad..
People are taking about this as an easy mod.
I would say it is a hard one.
How can you use a thicker blade than what the actually cap is between the HS -I just dont get it. If I push hard -it just...
But is only the cuttingedge that I can get in between the HS.
The layer is so very thin -about 0,5mm -Is this normal?
Tried a second time now to remove the IHS.
Damn I cant do it.
I cant find a thin blade to get between the IHS and the cpu.
Yours must have been a thicker layer.
It just pisses me off.
Didt yours...
No PoL #456
But yor didnt mod your HS to fit the core?
how did you mod the HS? Is it a Zalman7700CU?
I would really like to know if my Zalman7700CU would make contact to the core after removing the HS?
But are you getting higher OC?
Today I tried to remove the IHS, but I havent got a thin blade to get cut the IHS off.
The layer is only about 0.5mm thick.
Im not sure I can thighten the...
But how can I know it is the heat holding me back.
I cant get it stable over 2700mhz -Giving it more vcore doesnt help either.
Im running 1.6V now and it gets 52C at prime95.
I can boot at higher...
Have been reading this thread now -It took a while.
I think I may have a nice NC 3400+.
It is only prime stable at 2700mhz (1,6V) but I cant boot up to 2820 (1,75V)
My temp when running prime95...