Not a single editor or visitor to the display suite figured out it was a TN panel until they were told. Even at that point, most did not believe it. ;)
Type: Posts; User: bingo13; Keyword(s):
Not a single editor or visitor to the display suite figured out it was a TN panel until they were told. Even at that point, most did not believe it. ;)
I can show pics of various coolers on the board after NDA lift and some benches that will embarrass competing boards. :D
As one running 301.10, it is not fully compatible yet...on certain boards not starting with AS.. ;)
Well, you would need to cut off about 30% of that chip to fit and by then it might not work.... :p:
It should not be too bad on pricing and I bet it clocks better than anyone can imagine. ;)
and in the US, EU and I hear Mars also... :rofl:
I cannot obviously say what is real or not for a few more weeks but those screenshots remind me of the last time I had a vegetarian breakfast with Elvis and Bigfoot while sitting on the rings of...
It is copper piping.
I have no idea what is worse, all the assumptions made in this thread or the one in the IVB thread. :p:
I am waiting on reputable sites like DigiTimes to report benchmark numbers before setting my expectations. :rofl: Oh wait, I guess I could just benchmark the card sitting here and see if those hopes...
Well, you probably asked the wrong person. :p:
Sabertooth is not too bad, H60, 32GB of cheap ram and a very expensive MarsII to keep things warm...
...
Good Day,
Can you please PM me your serial number on the board and any RMA information.
Sincerely,
Gary
0075B posted at the start of this thread. It will be updating the ROG firmware also, so it will be a two step 3~5 minute process.
Did you change the memory speed from 1066/1333 to 1600 or higher? Also, please PM me with your RMA case numbers and current serial numbers on the EVO board and 2600K.
I need to know your EFI release number - 0709? 0802? - and the memory kit manufacturer and part number please.
I need to know your EFI release number - 0709? 0802? - and the memory kit manufacturer and part number please.
This took about 3 minutes to setup including POST, Configure EFI - XMP 2400, increase BCLK, increase CPU Multi, rest is Auto, POST, enter Win7 and start testing. I would suggest not overthinking it...
Any EFI above beta 0027 starts getting BD support and from that point forward it becomes more and more difficult to run Thuban or Deneb up high, sorry but the AMD AGESA code changes dictate most of...
Hi Dave,
We will have a new EFI shortly with some memory and core unlocking improvements. However, on the drive side this the first problem I have seen. Can you please PM me your drive model as I...
Run the kits at 2T, if you have version 5.1 on the memory, it is hynix that has been binned to get to 1866 C9 2T and 1T will be difficult. I have four modules here and three will not run at 1T stable...
We just received these from Corsair and you need to run them at 2T. I will have some additional settings on the CVF next week once we complete testing on them.
I can match that but with 8GB. :p:
We have considered doing a Crosshair Gene board with 990X or 990FX. The only question is if there is enough interest to do one. ;)
A good fake would have accounted for the multiplier lock on B0, hint it is below 27x... :D
I would not believe that sheet either. I happen to know what the real slide looks like and not the Photoshopped version. ;) Plus it does not hurt to have an actual CPU on my desk. :p:
