Not sure if still relevant, but Asrock A-Tuning utility should just work fine for you. The version listed at the download section of your mainboard model is quite old though. So it might be worth...
Type: Posts; User: Hyperhorn; Keyword(s):
Not sure if still relevant, but Asrock A-Tuning utility should just work fine for you. The version listed at the download section of your mainboard model is quite old though. So it might be worth...
Reviews in German:
PC Games Hardware
Hardwareluxx
Computerbase
I see, you've also set Sensor=0 and SPD=0, because it takes forever when enabled. :)
Can you use DDR4-2666 with 100 MHz BCLK strap? I can.
I suppose these 8 GiByte modules are dual ranked. So how...
Any info out there about Micron D9RLT, e. g. regarding capacity? (Upper line says 3RAI8 and on the side I can read QLF3.) I've seen it as SSD cache, but not on RAM sticks yet.
1M @ 720 MHz FSB is really nice. :clap: I am only aware of two guys who have 730 MHz and above validated with CPU-Z. :)
Info from Scythe directly: http://www.scythe-eu.com/en/press-room/press-releases/us-office/us-office-en.html
w00t! I'm curious what BCLK you will be able to reach with this board.
Looking over to Hwbot certain Supermicro boards looks promising for high :rolleyes: values of >105 MHz, but there are still...
The review sample of F3-2400C10D-8GTX (SN: xxxx1500xxxxxx) I recieved have 8 ICs per side of the PCB and are good e. g. for P95/Blend at 1200 MHz with 11-11-11-33 and 1.50 V, but are not suitable for...
Congratulations Xtremesystems! I may not have many postings, but I'm visiting the forum on a daily basis and learned a lot from many users over the years. Thank you for this opportunity!
I think it's incredibly boring to watch two guys trying to get the best Wprime result out of their expensive-as-hell-setups which can't get properly overclocked. :rolleyes:
So may I join? :rofl:...
1.633.8 MHz with 16 GiByte is nuts! Good job!
What about a memory overclocking stage at the next Gigabyte EOC? :D
Awesome thread, thank you for sharing the information! :clap:
I'll take a deeper look later ...
Interesting
I used the red slots and could run DDR3-2000 8-8-8-24 at Prime 95 until I stopped it. With the Cellshock sticks it didn't matter if black or red, frequency limit was in the low-mid 7xx...
That should run fine, because some minutes ago I've put 2 x 1 GiB Crucial BL12864BA2009-8SFB into the setup and have no issues at all. I could boot DDR3-1600/1866 at the very first try and now I'm...
Just something I want to share with you guys as I had a few minutes to test yesterday:
2 x 1 GiB D9GTR (Cellshock CS3222580) + FX-8150 + Crosshair V Formula (UEFI 1102) was really disappointing. I...
Sorry for new-resurrection, but besides that this is only a comparison with low significance (e. g. because of the different prefetch behaviour which decreases performance efficiency and the...
You will see higher binned kits this year, DDR3-3000 is around the corner. ;)
However I don't think 1.65 V can be considered "low voltage" anymore. LV nowadays means <1.5 V in my book.
It's pretty much the same here except I've voted for real-time hardware monitoring, too. If done right (e.g. OC Key) it's a pleasure to work with and a great plus in my eyes.
However I think "VRM...
B3 is the older stepping (gets warmer), that means it offers a lower overclocking potential than a G0 CPU on an average.
No coldbug sounds nice, but that might be a useless feature, if IB shares the multi/clock walls and almost not existing cold scaling abilities with Sandy Bridge. But hey, if it's true, you can at...
I know, it's a thread resurrection, but it's worth it, because I couldn't find a single thread/post mentioning, that our friend Duck managed to push a Celeron 360 to an astonishing clock frequency of...
This board is made for extreme overclocking (even if not labeled as "OC" but "UD7"), so additional slots just complicate the pcb layout and raise the price while for extreme overclocking basically...
MaSell said around 4 Volt and that he tested up to 4.2/4.3 Volt but that didn't improve the result (source).
Congrats here as well ;)
Really impressive numbers here, I'm curious what is possible with these CPUs.
tCAS=2 appears if you change the CPU multiplier on the fly.
Under certain conditions the Silver Arrow performance seems to decrease dramatically. It reminds me of this test:...