My dad has an LS1 TA 6 speed, and I think he pulls like 28-29 highway, he has 4.10's in it too.
Type: Posts; User: sandman; Keyword(s):
My dad has an LS1 TA 6 speed, and I think he pulls like 28-29 highway, he has 4.10's in it too.
Do you knw what gearing your TA has?
I'd be willing to bet your car is a decent amount lighter.
What sort of mileage do the tolan's get?
The S10 is an '89 with a 350 in it, so it'd be pretty quick. Has 85,000 miles on both the motor and the body. Geared pretty low, not sure what it is specifically, something like 4.10's in it I think....
www.under-the-ice.com
they have some good stuff, and they're run by runmc.
The pinhole one you close off.
It's a pilot valve.
At any rate the propane works, so why go to nitro?
I'd personally think that for an "optimal cascade" something lkike an SC18MLX for the first stage and then a SC12MLX for the second stage would be about Ideal.
Or just add some R290 to the R134A. Depending on the compressor, changing the oil might not be a bad idea anyway.
Same restriction equals same flow in a perfect system.
However oil is more likely to clog up in the smaller diameter cap-tube.
It's because we are removing much smaller heat loads at lower temps, generally speaking.
Also, more refrigerant from the cap-tube is basically nil, take a look at how much room there is inside the...
I pulled one apart, and it used R22. Panasonic R22 rotary.
Honestly, I had some of this stuff, and while it was nice, I found that 15% with some flux holds just as well, and is actually easier to use.
I'm assuming this is for stainless steel suction hose?
He got them from chilly1 I beleive.
I got a couple for a cascade I'm building, and they're very nice.
You seem to think everyone here drives a V8 that gets 10mpg.
I have a small V6 in my car, and it gets roughly the same mileage as a 4 cylinder, because it is running lower rpms that a 4 cylinder. ...
Do you realise this topic isn't even about bush? It's about the flood.
It isn't bush's resposibility to do anything about building dams in the first place. Why didn't Clinton build dams? Why...
Nice setup.
175psi seems a bit low on teh high-side to me?
BTW, cool power supply.
Wet caps?
Forgive me ignorance, but what does this mean? or is it completely literal?
Would you consider my soul?
What about parting it out?
Yep, he didn't really seem toc are about losing a compressor at all.
Just told me to keep the old one.
I would try taking about 5-6" off of it.
That happened to me too, I asked him about it, and he just sent me another one for free, it was for 134A.
Ok, so I have a couple copeland compressors here, they use a run and start cap, along with a potential relay.
I've seen a few different diagrams, and tried them, but they don't work.
If anyone...
He doesn't run it, he just posts articles on the front page.
I was, I'm a year older though.
In my case it would be homocide, but that's fine because no one would notice the jackass was gone.