OCN2

Search:

Type: Posts; User: Hyperhorn; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Not sure if still relevant, but Asrock A-Tuning...

    Not sure if still relevant, but Asrock A-Tuning utility should just work fine for you. The version listed at the download section of your mainboard model is quite old though. So it might be worth...
  2. Replies
    20
    Views
    4,509

    Reviews in German: PC Games Hardware...

    Reviews in German:
    PC Games Hardware
    Hardwareluxx
    Computerbase
  3. Replies
    22
    Views
    19,294

    I see, you've also set Sensor=0 and SPD=0,...

    I see, you've also set Sensor=0 and SPD=0, because it takes forever when enabled. :)
    Can you use DDR4-2666 with 100 MHz BCLK strap? I can.

    I suppose these 8 GiByte modules are dual ranked. So how...
  4. Replies
    223
    Views
    142,765

    Sticky: Any info out there about Micron D9RLT, e. g....

    Any info out there about Micron D9RLT, e. g. regarding capacity? (Upper line says 3RAI8 and on the side I can read QLF3.) I've seen it as SSD cache, but not on RAM sticks yet.
  5. Replies
    36
    Views
    7,016

    1M @ 720 MHz FSB is really nice. :clap: I am only...

    1M @ 720 MHz FSB is really nice. :clap: I am only aware of two guys who have 730 MHz and above validated with CPU-Z. :)
  6. Replies
    24
    Views
    3,354

    Info from Scythe directly:...

    Info from Scythe directly: http://www.scythe-eu.com/en/press-room/press-releases/us-office/us-office-en.html
  7. w00t! I'm curious what BCLK you will be able to...

    w00t! I'm curious what BCLK you will be able to reach with this board.
    Looking over to Hwbot certain Supermicro boards looks promising for high :rolleyes: values of >105 MHz, but there are still...
  8. The review sample of F3-2400C10D-8GTX (SN:...

    The review sample of F3-2400C10D-8GTX (SN: xxxx1500xxxxxx) I recieved have 8 ICs per side of the PCB and are good e. g. for P95/Blend at 1200 MHz with 11-11-11-33 and 1.50 V, but are not suitable for...
  9. Replies
    59
    Views
    7,450

    Congratulations Xtremesystems! I may not have...

    Congratulations Xtremesystems! I may not have many postings, but I'm visiting the forum on a daily basis and learned a lot from many users over the years. Thank you for this opportunity!
  10. Replies
    35
    Views
    14,178

    I think it's incredibly boring to watch two guys...

    I think it's incredibly boring to watch two guys trying to get the best Wprime result out of their expensive-as-hell-setups which can't get properly overclocked. :rolleyes:

    So may I join? :rofl:...
  11. Replies
    16
    Views
    2,704

    1.633.8 MHz with 16 GiByte is nuts! Good job!...

    1.633.8 MHz with 16 GiByte is nuts! Good job!
    What about a memory overclocking stage at the next Gigabyte EOC? :D
  12. Sticky: Awesome thread, thank you for sharing the...

    Awesome thread, thank you for sharing the information! :clap:
    I'll take a deeper look later ...
  13. Replies
    845
    Views
    151,793

    Interesting I used the red slots and could run...

    Interesting
    I used the red slots and could run DDR3-2000 8-8-8-24 at Prime 95 until I stopped it. With the Cellshock sticks it didn't matter if black or red, frequency limit was in the low-mid 7xx...
  14. Replies
    845
    Views
    151,793

    That should run fine, because some minutes ago...

    That should run fine, because some minutes ago I've put 2 x 1 GiB Crucial BL12864BA2009-8SFB into the setup and have no issues at all. I could boot DDR3-1600/1866 at the very first try and now I'm...
  15. Replies
    845
    Views
    151,793

    Just something I want to share with you guys as I...

    Just something I want to share with you guys as I had a few minutes to test yesterday:
    2 x 1 GiB D9GTR (Cellshock CS3222580) + FX-8150 + Crosshair V Formula (UEFI 1102) was really disappointing. I...
  16. Sorry for new-resurrection, but besides that this...

    Sorry for new-resurrection, but besides that this is only a comparison with low significance (e. g. because of the different prefetch behaviour which decreases performance efficiency and the...
  17. You will see higher binned kits this year,...

    You will see higher binned kits this year, DDR3-3000 is around the corner. ;)

    However I don't think 1.65 V can be considered "low voltage" anymore. LV nowadays means <1.5 V in my book.
  18. Poll: It's pretty much the same here except I've voted...

    It's pretty much the same here except I've voted for real-time hardware monitoring, too. If done right (e.g. OC Key) it's a pleasure to work with and a great plus in my eyes.

    However I think "VRM...
  19. Replies
    8
    Views
    2,462

    B3 is the older stepping (gets warmer), that...

    B3 is the older stepping (gets warmer), that means it offers a lower overclocking potential than a G0 CPU on an average.
  20. Replies
    432
    Views
    81,003

    No coldbug sounds nice, but that might be a...

    No coldbug sounds nice, but that might be a useless feature, if IB shares the multi/clock walls and almost not existing cold scaling abilities with Sandy Bridge. But hey, if it's true, you can at...
  21. Replies
    103
    Views
    22,203

    Duck does it agin - Celeron 360 pushed to 8,320.4 MHz

    I know, it's a thread resurrection, but it's worth it, because I couldn't find a single thread/post mentioning, that our friend Duck managed to push a Celeron 360 to an astonishing clock frequency of...
  22. This board is made for extreme overclocking (even...

    This board is made for extreme overclocking (even if not labeled as "OC" but "UD7"), so additional slots just complicate the pcb layout and raise the price while for extreme overclocking basically...
  23. Replies
    40
    Views
    7,410

    MaSell said around 4 Volt and that he tested up...

    MaSell said around 4 Volt and that he tested up to 4.2/4.3 Volt but that didn't improve the result (source).
    Congrats here as well ;)
  24. Really impressive numbers here, I'm curious what...

    Really impressive numbers here, I'm curious what is possible with these CPUs.
    tCAS=2 appears if you change the CPU multiplier on the fly.
  25. Replies
    13
    Views
    1,752

    Under certain conditions the Silver Arrow...

    Under certain conditions the Silver Arrow performance seems to decrease dramatically. It reminds me of this test:...
Results 1 to 25 of 488
Page 1 of 20 1 2 3 4