Search:

Type: Posts; User: Shoggy; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: Flow Issue

    by Shoggy
    Replies
    4
    Views
    1,561

    Absolutely OK and to be honest it evens surprises...

    Absolutely OK and to be honest it evens surprises me that it is that high with the mentioned setup. I quite often think many users have a very unrealistic expectation about the flow rate. Apart from...
  2. Replies
    6
    Views
    1,827

    Have you noticed that the failed address always...

    Have you noticed that the failed address always changes by 4 steps? Hard to believe that this is a natural random problem and given the fact that these are super small steps this system should not be...
  3. Replies
    6
    Views
    1,827

    Almost impossible that the aquaero is the real...

    Almost impossible that the aquaero is the real reason here. It is more likely that the used VM has a bug with its HID handling for the USB.
  4. Replies
    3
    Views
    881

    No problem at all. We had two Laing D5 pumps + 40...

    No problem at all. We had two Laing D5 pumps + 40 fans running without any problems in a demo.
  5. Important note for Aqua Computer products with a mps controller board

    Unfortunately we have found a problem with our products that use the mps controller board. Products that have been dispatched after April 17th 2014 (our warehouse) maybe have a reversed port for the...
  6. Replies
    17
    Views
    2,047

    Small update. I have the numbers now. The caps...

    Small update. I have the numbers now.

    The caps on the left can have 6.75mm in height while the row on the right can have 10.5mm.
  7. Replies
    17
    Views
    2,047

    Do you own a sliding caliper? If so, could you...

    Do you own a sliding caliper? If so, could you please take the height from the PCB to the top of the blue colored caps on the left and right. When I am back in the office I can check what the maximum...
  8. Replies
    17
    Views
    2,047

    So, if you own so many 290 cards you could also...

    So, if you own so many 290 cards you could also use the MSI card for the water block. So far I can only say that every time we had any kind of problems with a 290 card it were always cards that had...
  9. Replies
    17
    Views
    2,047

    No idea if the MSI card is from someone else or...

    No idea if the MSI card is from someone else or if it is yours. If you have access to it you should compare the height of the caps and the molded coils left to it (these black boxes with the "C")....
  10. Replies
    17
    Views
    2,047

    I am pretty sure the card is the problem since it...

    I am pretty sure the card is the problem since it is also not a reference card. Easy to spot because of the missing AMD imprint above the PCIe contacts. I had a customer with the same problem in the...
  11. If you already sent an e-mail and also got an...

    If you already sent an e-mail and also got an automatic confirmation you will get a reply for sure. At the moment we are drowning in e-mails.
  12. Replies
    111
    Views
    44,219

    Yes, of course it is acyrlic glass again.

    Yes, of course it is acyrlic glass again.
  13. Replies
    111
    Views
    44,219

    By the way: our Hawaii blocks are also available...

    By the way: our Hawaii blocks are also available with black glass now :)

    Nickel plated and copper.
  14. Replies
    111
    Views
    44,219

    If you remove it the block is not sealed anymore....

    If you remove it the block is not sealed anymore. There is gasket below it. This area forwards the water to the voltage regulators.
  15. Replies
    9
    Views
    1,452

    Have you also tried to lower the key sensitivity...

    Have you also tried to lower the key sensitivity in the software?

    It is OK that the pins stand out a bit. They are long enough to make contact in the connector.
  16. Yes, of course.

    Yes, of course.
  17. By the way: the aquaero 6 is listed in the shop...

    By the way: the aquaero 6 is listed in the shop since yesterday ;)

    Yesterday...

    http://forum.aquacomputer.de/images-ac/aquaero_prototypen_thumb.jpg

    Anyone needs an aquaero 0.02? :D The photo...
  18. Without side brackets and faceplate I get 27.7...

    Without side brackets and faceplate I get 27.7 mm.

    It will also have the voltage drop since the signal must go through the voltage regulators. It is like you would set it to 100% but with the PWM...
  19. You could use a colored foil but I guess it will...

    You could use a colored foil but I guess it will not look that good and also the brightness will be lower.

    You can use PWM control or voltage control on all channels. You can use 3-pin or 4-pin...
  20. aquaero 6 - power to the people - err, I mean fans and pumps

    The new aquaero 6 is an improved version of the aquaero 5. Our main target was a dramatic increase of the available power on the outputs. Other than the aquaero 5 which works with an analog voltage...
  21. Replies
    17
    Views
    2,624

    Just as confirmation: the GTX 480 and all blocks...

    Just as confirmation: the GTX 480 and all blocks above use 0.5mm pads.
  22. Replies
    60
    Views
    36,934

    A blue one for example....

    A blue one for example.
  23. Replies
    60
    Views
    36,934

    The LEDs are normal 5mm LEDs. You should get them...

    The LEDs are normal 5mm LEDs. You should get them easily anywhere where you can buy electronic parts. We also offer these LEDs as single parts or complete kit with resistor, cable and 4-pin Molex...
  24. Replies
    227
    Views
    68,556

    The block was designed to have no contact to...

    The block was designed to have no contact to these inductors. I can not tell how much space is left between them and the hollow in the block but it should not be that much. Of course with an...
  25. Replies
    227
    Views
    68,556

    Just in case you would use thermal pads on the...

    Just in case you would use thermal pads on the RAM there is a good chance that the GPU will have no more proper contact to the block.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4