Search:

Probably on weekend I will test the majority of bioses for the dfi and look if there is one for my combination of hardware to suit 300+ htt and low divider.
But as I said before for his price it is...

For me it is kinda curios. No matter how loosen i set the timings I wont get into windows at 300 htt. It just stops booting after the nvidia raid screen appeared anf it should back up cmos.
If I...

Your right G.S Technican for this price here in germany its an absolut fantastic ram. Except the divider problem it is for about 20~30 Euro more than a normal noname ram-kit with cas3 a super cheap...

Hi bachus_anonym. I tried your settings, even the bios like you. But no chance to get into windows with low dividers. All I want from this ram is too run at 200 mhz, rated timings and a low divider....

I think it depends on how much your ram will do. For mine its about 241 mhz with divider and about +10 mhz with 1:1. As I can't use lower dividers, 290-293 super-pi 32m stable is the end for me. ...

I also got a pair of these 1gb gskil GBZX. But I also have the problem to boot with a divider under 166. They run just fine at 290 Mhz HTT with divider 166 and the settings posted by G.S Technician...

Yesterday i read over at vr-zone.com that someone was able to activate HT on a P4 NW 2,4(133x18).

(http://www.vr-zone.com/Home/news170/HT.htm)

I know I could be a engeneering sample of a 3.06...

Chips are little bit warmer as before but not really hot ( and they are also passiv cooled by Leadtek standard cooler. Testet it with artivact tester and ut2003 direkt after boot. UT shows at 570...

Got it work with 1 kohm resistor at pin 14 and ground.(The same as sc1102). Have 3.92 volt on mem.....but nothing can't go higher than 550Mhz. Any suggestions why?

Hi, to you all. I'm new here and my english is bad becaus german. I've got a short question about volt mod Leadtek gf4 ti4200(64MB 4ns Eltron, nv25 A3 Stepping 310/ 550 w/o volt mod).
The problem...