Search:

in your signature it says you have a P5B Deluxe?
which has a P965-chipset...
would be great if you added that board to your tests :p:

nice comparison though! :clap:

let's see C3 plz :)

even on XS the number of people needing 8GB is rather low
and 4GB can still be done with 4*1GB
I'm doing 850MHz 3-4-4-8 @ 2.33V, with 4Gb, right now :)

intresting read

but what do you guys mean by "drive strength"?


Can electromigration be stopped or slowed down by cooling? (water or subzero)

if you mean "do they still work?"
yes
but alive and kicking
... no :p:

I had simular problems with my D9GMH.
After giving them 3.15v they wouldn't boot at a vmem between 1.95 and 2.3v.

i think the only solution is to ban P965, or to give it its own category
on many P965 boards C3 is just way too easy
I've been testing some and in many cases C3 was slower than C4!

hmm, grounding... sounds like a great idea :D

so what pin should I connect in order to ground the compressor?
Or should I just connect a grounded wire to the case?

it's my pump, Jort only made the chiller

yesterday i let it run for a few hours, no problems occured :)
this is the result after 1/2 hour :D...

That's probably the only piece of hardware you haven't kill yet :stick: :D


Keep up the good work :banana:

Sicce Idra 1200l/h

ok, that worked
thx :)

http://bacict.kahosl.be/simon.allaeys/DOWNLOADS/pc/chiller/block2.jpg
I couldn't measure temps 'cause my multimeter broke down today :(

But I've got some more...

:woot: :clap:

could you tell us which voltage you were using? :)

Jort didn't have time to completly finish it,
this is how I recieved it.
I only had to connect the controller and the tubes + isolation.

Is this what you need?...

I'm installing my waterchiller so I can use it for the first time.
But I have a problem with the compressor.
This is how it's connected to the net.

This doesn't work.
So I used google, and I...

haha :D

the cheapest one :)

any D9GMH

so many jumpers between the pci-slots, what are they for?
how does that sb-cooling work?

would you say this board is better then the Asus P5B-E?


cpu-connector, 8-pins, like they needed with...

What nb cooling do you use?

Team Xtreem D9GMK PC2-5300 @ 3-3-3-4 333MHz @ 1.85v
They are dying and have an 'unstable zone' between 1.95v & 2.3v, so i'm careful with them till I get a 4Gb kit

http://www.madshrimps.be/?action=getarticle&number=4&artpage=2100&articID=503

I assume you've had bad luck.
I'm able to pass 500MHz without any voltage increasement.
(My P5B-E has C1 chipset revision)

I doubt that, not even my D9GMH can do that a normal voltage. You need Fatbody D9 if you that is your goal ;)


Yes, I know :) I still didn't have time to do the vmch mod. I'll see if I can...

P5B-E is a far better choice.
I owned both, DS3 sucks bigtime.