Search:

You'd need a specialized vacuum sealed evaporator system. And you'd get a -200C at 10watts.

The charges are certainly expensive!
I think we can make that mix for far less though. And even less still if we look through Mytek work with hydrocarbons.

Sadly these aren't the mythical unicorns they look like. The box is just a compressor condenser oil separator. The hoses and cold head provide all the heat exchange and capillary lines. And while the...

Yep chillers.
I just finished a few. So many plate HX in inventory to move.

Looks like they fixed the micro stutter Charles!
Congrats on an epic achievement.

Pretty sure it's a Kayl stepper.

Just wanted to share something awesome.
I used to have a good source on these Yellowjacket stainless steel braided flexible lines. They obviously have the brass 1/4" lines on them that go on to...

To be honest I'm not surprised. I always felt like they made nice looking.... piles of crap.

K type probes should all be the same. No worries about green or white, those are coatings for high temperature protection.
As for cheap and accurate, a PID temperature monitor is around 30$ and goes...

Easy peasy! You will probably want to cook up a quick backplate as well.

There are so many other holes on a GPU, and you could maker a bracket to extend out the holes with its own insulating plate.
I'm based out of Hershey PA these days, but I live and work part time in...

Pickup a cheap cutting board. Thick. Half inch or so. Use that to make a plate with mounting holes that bolts to your existing mount.

Just some condensation. Add a little more armaflex or insulation tape over that spot when it's off and dry.

The liquid return isn't really because of a short suction length though is it?
It's because your overcharged or your load is too little and liquid isn't boiling off in the evaporator.

Why wouldn't it be okay?
What are you worried about with a short suction?

The power consumption is 500w I bet.

Well typically the rules on captube is 6 to 10ft. Once you cut down less than 6ft, go back up to 10ft of the next larger capillary size.
You stop cutting when your happy with how the system is...

That's basically just what you asked for. Skipping the hard part.
Captube tuning is literally the entire hard part of building phase units.

There is no formula, only raw experience. And without...

What kind of single stage?

If you dont have equal length lines at equal heights, then one compressor will get more of the oil. That one will flood and choke. The other will starve and overwork.
It's easier to just use a...

I've tried split systems before with rotaries. You have two options. Can drill a hole in the bottom bend under the accumulator and link them up.
Or.. we use tiny systems in terms of condenser and...

Yes just like that.

I'm on a phone so cant. It will be a normal system. Straight normal setup. Except, two compressors side by side. Right out of the discharge merge the lines then into condenser. Out of evap, suction...

Sure you can if they are the exact same. Just merge the suctions and discharges with T fittings before the condenser.

Please consider a full atx one of these.