Originally Posted by
saaya
There seem to be at least half a dozen cases of dead elpida hyper based sticks that died nowhere near the known danger zone north of 2v but at a measly 1.65-1.75v... :( if you are one of the poor b4stards who had one of those sweet sticks roll over and die, please post as many details about it in this thread so we can find out whats causing it, and hopefully prevent it from happening in future :toast:
If this happened to you with samsung based memory or any other memory chip or you are not sure what chips your sticks use, but they also died at low vdimm, please post your experience here as well, it might not be an elpida hyper problem after all...
please answer as many of the questions below, ideally all of them:
Just quote this post and then add your reply under each question
1.) How did the memory die? Idle, load, reboot?
2.) What exactly happened? freeze, errors, crash, system turned off, system rebooted, blue screen, black screen
3.) What board, pcb rev and bios version did you use?
4.) What speed and timings did you run the memory at when it died?
5.) what speed and timings did you run the memory at most of the time?
6.) What vtt did you run when the memory died?
7.) what vtt did you run the memory at most of the time?