FX-8370 - non E version

I have one 1430PGS with high SN. I believe the power of low SN is in most of cases real. But this one is not bad afterall, not the best, not the worst.

This 8370 scaling very well with lower voltage, after this is handbrake and I must set much higher voltage and I got only 200 MHz more :-/...Hope, some highskill level guys as Stilt or *Chew wake up for some time and show how good can be 8370/8370E at his side with daily cooling method (air or allinone liquid).

First only this the best effectivity for Cinebench. Good voltage, good frequency:
https://farm4.staticflickr.com/3889/...148aba95_c.jpg

Did you do a speed run on this one yet FlanK3r, just curious how it does with your AIO??

srry for my english, what do you mean with speed run?:)

Just for validation, the last one pretty impressive at 5.8 just wondered if this was similar ?

8370 and 8370e are the same price. Which is better for OC?

seems, in my case, 8370E a little better for air. But I cant say it, because I have only one plus one new CPUs :-D...Today I will test quicker few last benchmarks at 8370.

I've been tempted to take one of these for a run sometime. Maybe when the weather gets colder here, winter is on it's way . Muahahaha

Quote:

---

Originally Posted by Johan45

I've been tempted to take one of these for a run sometime. Maybe when the weather gets colder here, winter is on it's way . Muahahaha

---

I'd say, if you have the spare cash go for it Johan45...
I noticed you have a 9370 that was on par with mine. I always wanted to get it 5Ghz stable and never could. :(
The E version is a lot of fun to play with, and I finally got my 5Ghz!

From a frugal point of view it may be silly, since the chip cost me $200 and I only got an extra 200Mhz ($1/Mhz).

On the entertainment side of things, I've had hours of fun with this chip and I'm not close to being done yet... :D

Johan, give me next one day. I was lazy yesterday and free time of Saturday was sport activity and some readings. So hope today evening I could some time for OC :)

Here are some results with my 8370

Cooling was with a Promlimatech Megahalems CPU cooler and two Artic F12 fans in push/pull configuration.


First test was to see the lowest voltage needed for 5ghz which was 1.42v which rose to 1.44v under load

http://img.photobucket.com/albums/v1...psddc7dfbf.jpg

Brief test with AIDA64 at 5124 MHz, 1.5v

http://img.photobucket.com/albums/v1...ps792792ad.jpg

http://img.photobucket.com/albums/v1...ps0ba9dd92.jpg


Cinebench R11.5 and R15

http://img.photobucket.com/albums/v1...ps81f66681.jpg

http://img.photobucket.com/albums/v1...ps8655aaf8.jpg


wPrime at 5192 MHz

http://img.photobucket.com/albums/v1...ps4e3ad11b.jpg


Pifast at 5350 MHz

http://img.photobucket.com/albums/v1...psbd286c5c.jpg


SuperPi at 5398 MHz

http://img.photobucket.com/albums/v1...ps8583239a.jpg


Maximum validation on air cooling was 5513 MHz

http://valid.canardpc.com/kdc20l

http://valid.canardpc.com/cache/screenshot/kdc20l.png

finioshed, tomorow morning I will upload it, now Im too tired. BTw, my 8370E is a bit better.

So. there are few results with allinone cooler. The difference between this FX-8370 and 8370E from another thread is around extra 50 MHz for my FX-8370E in hard benchmarks. For validation is FX-8370E better more than 150 MHz! For light benchamrks it could be +50-70 MHz. But with FX-8370E I was not focused so much for maximum of SUperpi as in this case... What about CPUNB? Again, 8370E seems a bit better, for the same frequency I need more voltage at FX-8370. For 2700+ MHz with 8370E it was around 1.25V, here 1.3 V.

Now some banchmarks.

low voltage max Cinebench
https://farm3.staticflickr.com/2941/...3fdf8c90_c.jpg


HWBOT PRIME
https://farm3.staticflickr.com/2948/...0650edf5_c.jpg

Cinebench R10
https://farm4.staticflickr.com/3879/...fb0c86cb_c.jpg

Cinebench R11.5
https://farm3.staticflickr.com/2943/...070fef0d_c.jpg

Cinebench R11.5+high CPUNB
https://farm4.staticflickr.com/3836/...e8b0919d_c.jpg

Cinebench R15
https://farm4.staticflickr.com/3905/...a9b03d8c_c.jpg

Superpi1M under 14s
https://farm4.staticflickr.com/3931/...cca7620f_c.jpg

Superpi 32M at 5400 MHz
https://farm3.staticflickr.com/2943/...1deaa127_c.jpg

max validation process:
https://farm4.staticflickr.com/3856/...fd8d9b5f_c.jpg

Ya know Daveburt714, I just might have to do that so far these CPUs look preety sweet. I'm impressed with your results on ait too topdog. I know that's a big azz cooler but still there weren't too many 8350s I saw that would do that. Thanks for the results guys, I'm just tossed up on where to spend my money, New 8370e , new 980Ti , both??? Oh so many decisions.

8370E for the win!

AMDeeeeee

Amd needs a trade in program for the FX chips to get new FX chips

Could someone check if these run correctly on Crosshair IV Formula/Extreme?
I can't get dual channel with my 9370 on CH4F, while it runs fine with 8350.
Also I need 2 restarts to make it work, otherwise it tries to use the default multiplier and with 300 HT Ref obviously it can't boot on water :p
Need to turn it off - turn on again - board loads failsafe settings - enter bios - F10 - restart and then it works.

Quote:

---

Originally Posted by I.nfraR.ed

Could someone check if these run correctly on Crosshair IV Formula/Extreme?
I can't get dual channel with my 9370 on CH4F, while it runs fine with 8350.
Also I need 2 restarts to make it work, otherwise it tries to use the default multiplier and with 300 HT Ref obviously it can't boot on water :p
Need to turn it off - turn on again - board loads failsafe settings - enter bios - F10 - restart and then it works.

---

Not sure if this will help or not Infra,

I picked up an 8320E today and tested it in the C4F. I didn't experience any of the problems you mentioned above...
Dual Channel memory worked fine and no need for multiple restarts or power cycling (wasn't pushing HTRef though).;)

I did notice some throttling of the CPU clocks when under load, even though I had OCP and other power saving/protection features turned off... :rolleyes:

Here's what I got after an hour or so of tinkering with it:
http://i30.photobucket.com/albums/c3...ps7000fb0d.png

It seems like another nice chip! I get the feeling the C4F was holding it back a little.
I'll probably move it to the main rig next weekend just to check.

The Sabertooth is a nice board if your thinking about ditching the Crosshair IV. :yepp:

Hope this helps,
Dave

I wanna next 8370/8370E with low SN...Any can help me?:)

Thanks for the test, Dave!
The throttling is because you can't disable APM through bios, but I've noticed that above certain HTRef there's no more throttling.
I have Crosshair V Formula, but I use it for benches only. Crosshair IV Formula is in the main rig and it has a full-cover block mounted, which helps a lot.

I found second C5F in my box...But I muts test it, if is OK and working. (I use C5F-Z in my PC and C5F for benchtable)

Quote:

---

Originally Posted by I.nfraR.ed

Thanks for the test, Dave!
The throttling is because you can't disable APM through bios, but I've noticed that above certain HTRef there's no more throttling.
I have Crosshair V Formula, but I use it for benches only. Crosshair IV Formula is in the main rig and it has a full-cover block mounted, which helps a lot.

---

I'm pretty sure if you disable turbo core tech through AMD OD it will also disable the APM. Has to be done through the software though. Just FYI

Yes, it works with AOD, but can't be disabled through bios.
However at high HTRef, I don't need this trick. Probably related to the fact with that high HTRef I'm using lower multi than turbo.

That's a nice work around. Wonder if that works for other baords??

no, only for C4E+C4F. I have both :)

Thanks FlanK3r.

So are 8370/8370e high leakage/low leakage or are they basically the same?