Quote:
1 - i enlarged this hole. the 6pin PCIe wire and 4pin EPS 12v will go through this hole, and the EPS wire will again go back through the mobo backplate hole
2 - this hole gave me the most trouble, and it had the most work redone to it. one molex/peripheral strand will go through here, and the only SATA strand will also go through here. the SATA data cable will also use this hole
3 - the second molex/peripheral strand will be hidden up here. there was hole cut out at the very inner front for the wires, but it doesn't look like that will be needed. there will be a molex-to-SATA adapter connected to this wire for the optical drive
4 - this was a large rectangle cut-out, but only the 24pin main cable will go through here.
5 - this hole is for the front panel USB cable and audio/mic cable that will be connected to the mobo. the SATA data cable will also be used here
6 - this hole i just cut out also while the case was intact and already painted. the bundle of power/reset/HD LED/power LED goes through here since all the cables were too short to go through hole #5
(all the other holes dremeled turned to be useless and a waste of effort)
