Printable View
i wouldn't have a problem with it if you had well cooled 5b D, and you stop at 3.0v but since you have UCCC, it's a bit different, i don't know how that stuff works nearly as well :(
i'd hold off on going over 2.9v personally, especially since you'll probably only get like 3-4mhz out of it
for 24/7 i wouldn´t go over 2,9V
Kingston Value ram is carrying 5b-g's guys ;) (grabbed 4x512 for myself)
just did a little testing and i have to say i really love the ram :D
215mhz@2,5-3-3-8@only2,7V 1T dualchannel seems to be stable.. but i haven´t run prime so far only played about 3hours and made a SuperPI 1min run.. will do prime over the night
pic:http://www.xtremesystems.org/forums/...id=36958&stc=1
k just did a half hour priming and its´s not primestable with 2,7V :>
i think to get this ram primesatble >210 you have to get >2,8V.. but because in gaming there is quite no instance beween cas3 and 2,5 i will leave it @ 3-3-3-8 2,7V 1T and for benches i could use it with more than >2,7V with cas2,5
After i did final testing i found out that some of the 2gb crucial value sets don´t like 1T.. my highest primestable clock with 1T was only 215@3-3-3-8 2,7V.. but with 2T i´m already @235@3-3-3-7 2,65V primestable and there is still more in it..
and special for gaming there is no differnce between 1 and 2T ..
Any updates with the UCCC chips/OCs?
2.5-3-3-8 2.8vdimm 200mhzQuote:
Originally Posted by bushmeal
Doc, can you get is any higher? Guys with the UCCC in Corsair were doing 260Mhz w/good timings.
havent tried...2.4ghz is good enough for the time being.Quote:
Originally Posted by bushmeal
pfsh :p:Quote:
Originally Posted by Doctor Carta
Anyone know if all the CT6464Z40B M8FD are using the new PCB design with BGA chips??
Thanks.
all .M*FD = FBGA