PROJECT: MM Pinnacle 300 (previously Ugly Duckling)

Quote:

---

Originally Posted by Kibbler

That's good to know and if so I'm not terribly worried about it, should be water-soluble now and forever yeah? I'm not planning to re-use these blocks immediately anyway, and since the new build will use 3/8-5/8 the comp fittings will eventually be retired as well. Biggest change in temps so far was going from 2x to 1x loops, and even then I only saw 1~2c increase in coolant temps.

---

As this is a slightly long work log, did I miss something?
When did you change from 2 loops to 1?

Or have I just lost the plot, again, still?

Quote:

---

Originally Posted by kgtiger

As this is a slightly long work log, did I miss something?
When did you change from 2 loops to 1?

Or have I just lost the plot, again, still?

---

About a week ago, I took out 1 pump, cleaned it and prepped it (pump top, mounting, etc.) for the next build.

Lol :ROTF: there's no plot in this worklog. If there was one it'd be as bad as (or good?) as Armageddon's.

Quote:

---

Originally Posted by Anemic

An absolute beaty of a build. Great work man!

---

Thanks man :)

When you striped the pump down, was there much of that white coating in it?

Do you think you will bother to replace the pump that you nicked, since it only changed the temps by 1~2c and based on that, Is the next rig going to have 1 or 2 pumps in it.

Quote:

---

Originally Posted by kgtiger

When you striped the pump down, was there much of that white coating in it?

---

Not a lot but yes there was, probably also from the rad. It's easy enough to clean but still, just 1 more reminder to flush all components thoroughly.

Quote:

---

Do you think you will bother to replace the pump that you nicked, since it only changed the temps by 1~2c and based on that, Is the next rig going to have 1 or 2 pumps in it.

---

New build will be 1 pump 1 loop.

Thanks kibbler for your feedback.
Looking forward to watching this next build of yours.