I was expecting the resistor/ trimmer values to be the same though. The mod is being applied across the same point, (isn't it?) but the trimmer values are ~3.5K Vs 10K for the same resultant voltage
Printable View
I was expecting the resistor/ trimmer values to be the same though. The mod is being applied across the same point, (isn't it?) but the trimmer values are ~3.5K Vs 10K for the same resultant voltage
I'm confused. Are you talking about the FB vmem mod or the FB OCP mod?
FB Vmem :)
If you guys have any problems applying very high clocks ( getting artifacts when you hit that nice apply button ) it might be due to... 2D/3D switch bug or the current temp isn't good enough.
With some cards you get a nasty 2D CB, you need to force the card to run in 3D mode all the time to be able to idle @ desktop ( obviously to apply high clocks :p: ) at very cold temps ( my best card can run 3D @ -188C, but at 2D anything colder than -124C results in artifacts/crash ).
I did a ninja BIOS edit before today's short session ( only 14lt of LN2 ) and it did work like a charm.
I'll upload it later on at the nVIDIA GeForce GTX 480 reference mods thread, need to get some rest asap, my eyes are "bleeding" at the moment :D
You wasted Ln2 like drinking water..:p
Bigger dewar next time will be very usefull...;)