Dayum! :eek: I can't go pass 251 @ 1:1 with 3.25v on the ram. Even with 3.3v mod and droop mod. It would be sweet if there was a way to drop multis :(
Most Xcellent work Hipro! :toast:
Printable View
Dayum! :eek: I can't go pass 251 @ 1:1 with 3.25v on the ram. Even with 3.3v mod and droop mod. It would be sweet if there was a way to drop multis :(
Most Xcellent work Hipro! :toast:
Diablo II
Well ASUS take some caps off in rev. 2.0 so it can cause the trouble... Anyway, actually almost no one really needs over 300 FSB except only a few xtreme ocers, so why asus should spend more on their boards? It seems quite logical from their point of view... :D
Thank you M8........ :toast:Quote:
Originally posted by Nebulous
Dayum! :eek: I can't go pass 251 @ 1:1 with 3.25v on the ram. Even with 3.3v mod and droop mod. It would be sweet if there was a way to drop multis :(
Most Xcellent work Hipro! :toast:
Try to "upper" your 3.3Volts on your PSU....... ;)
Have you tried to put the MAX Vagp into bios and give some more Vcore to the CPU???.....Quote:
Originally posted by ALT-F13
Diablo II
hmm, everything is possible, though i tried 5 different P4P800 (including rev.2.0) and no one can even come close to that one - 320FSB was the max for the best from other 4 boards. One died with smoke under NB while i tried 290 for the first time on it (couldn't work on 300 at all), two was around 300 and one - 320.
My current P4C800-E maxes out on 320 too (still on aircooled NB but i don't think it'll help to raise clocks) :(
can some one can please explain to me what is the connection between the agp/pci and the OC to the cpu and what it can cause?
what are the recommended limits for this value ?
IF your VGA card can handle 75 agp , then do it.......For best resaults you just HAVE to unlock the AGP/PCI bus over 66/33....... ;)Quote:
Originally posted by amisha
can some one can please explain to me what is the connection between the agp/pci and the OC to the cpu and what it can cause?
what are the recommended limits for this value ?
then the rate is beeing set by the chip set ?
what if the rate will be more then is can handle ?
is there sone article witch can answer all my questions ?